Skip to content

P0120: Throttle or accelerator pedal position sensor A circuit fault

There is a fault in the circuit of your throttle or accelerator pedal position sensor A. Usually a poor connector or a faulty throttle body.

This weekYou can drive gently home or to the garage. The car often goes into limp mode. Have the codes read this week.

How bad
This week
Do it yourself
Possible, if you are handy
Garage
Depends on the cause

What you notice

  • The engine warning light or EPC light is on
  • The car is in limp mode
  • Responds late or not at all to the accelerator pedal
  • Uneven idle

What usually causes it

CauseLikelihood
Loose or corroded connector on the throttle bodyCommon
Faulty sensor in the throttle bodyCommon
Damaged wiringSometimes
Faulty accelerator pedal sensorSometimes
Faulty engine computer (ECU)Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check that the connector on the throttle body is firmly in place and dry.
  2. 2Check the accelerator pedal connector under the dashboard.
  3. 3Have the signals of both sensors in the throttle measured.
  4. 4Replace the throttle body. Have it adapted with a diagnostic tester.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

With these codes the Saab switches to reduced power. The Saab 9-5 diesel stays in it until you switch off the ignition, even if the fault disappears on the way.

HELLA lists juddering, poor acceleration, poor starting and higher fuel consumption as complaints. Causes are a poor contact in the connector, moisture or oil in the sensor, and damage.

  1. First time the fault occurs

    The computer limits the power.

  2. Ignition off and on again

    The limit is lifted if the fault has gone. The code stays stored.

  3. Weeks of driving on

    The car can drop into reduced power again on the way.

  4. At the APK

    The APK inspector measures the exhaust gases. If they are too high, you fail the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Throttle bodyGarage nonePart €133

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

How the throttle position sensors work

The throttle body contains two position sensors. They share a 5 V supply and an earth, and each has its own signal wire. On the Saab 9-4X V6 they work in opposite directions: when you accelerate, the voltage of sensor 1 drops and that of sensor 2 rises.

The sensors cannot be replaced separately. They are part of the throttle body.

When the computer sets the code

P0120 is the general code for the sensor A circuit. The Saab 9-4X V6 splits the fault out: P0122 at less than 0.3 V and P0123 at more than 4.8 V on sensor 1. If the two sensors differ from each other by 7 to 10 percent, it is P2135.

The computer decides within 1 second. At Saab these are type A codes: the engine warning light comes on straight away.

In numbers

Sensor supply
5 V, shared1
Sensor 1 lower limit (Saab 9-4X V6)
0.3 V1
Sensor 1 upper limit (Saab 9-4X V6)
4.8 V1
Difference between the sensors
7 to 10 % gives P21351
Engine warning light on (Saab 9-4X V6)
Straight away, at the first failed test5
Computer response
Reduced power1

Questions

Can the throttle position sensor be replaced on its own?

On older cars, yes. On most newer ones the sensor sits inside the throttle body. Then you replace the whole unit.

What does a new throttle body cost?

Published part prices range from €132 to €134. Labour and adaptation come on top. According to the ANWB (the Dutch motoring club), cleaning or replacing costs €300 to €1,000.

Will P0120 make you fail the APK (the Dutch MOT)?

For most cars, not on the light alone. A car in limp mode can cause problems in the emissions test.

See also

Was this helpful?

· 7 sources · In het Nederlands

Sources

  1. Saab WIS, 9-4X 2011 V6: DTC P0121 to P0123, P0222, P0223 or P2135 (factory manual), checked on 19 November 2026
  2. Saab WIS, 9-5 2011 diesel: DTC P0122 or P0123 (factory manual), checked on 19 November 2026
  3. Saab WIS, 9-4X 2011 V6: Throttle Actuator Control (TAC) System Description (factory manual), checked on 19 November 2026
  4. HELLA Tech World, Throttle potentiometer: function and troubleshooting, checked on 19 November 2026
  5. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual), checked on 19 November 2026
  6. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch), checked on 19 November 2026
  7. ANWB, Throttle (in Dutch), checked on 20 November 2026
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.