---
title: "P0140: lambda sensor after the catalytic converter gives no signal (bank 1, sensor 2) · cause and cost"
description: "The lambda sensor (oxygen sensor) behind your catalytic converter, on bank 1, is not giving a usable signal. Usually it is a worn sensor."
canonical: https://vroomdoctor.com/codes/p0140
language: en
---


# P0140: Lambda sensor after the catalytic converter gives no signal (bank 1, sensor 2)

The lambda sensor (oxygen sensor) behind your catalytic converter, on bank 1, is not giving a usable signal. Usually it is a worn sensor. Replacing it costs €112 to €120.

No rushYou can keep driving, there is no hurry. Have it fixed before the next APK (the Dutch MOT).

9:41Golf 1.4 TSI

1 fault found

P0140

Lambda sensor after the catalytic converter gives no signal (bank 1, sensor 2)

How badNo rushDrivingYesUsuallyLambda sensorAsk your Golf something…↑

**How bad:**

No rush

**Do it yourself:**

Possible, if you are handy

**Usually:**

Worn lambda sensor after the catalytic converter

## What you notice

- The engine warning light is on

- Often you notice nothing while driving

## What usually causes it

| Cause | Likelihood |
| --- | --- |
| [Worn lambda sensor after the catalytic converter](https://vroomdoctor.com/nl/reparatiekosten/lambdasonde) · [€116](https://vroomdoctor.com/nl/reparatiekosten/lambdasonde#prijzen) | Common |
| Loose or corroded connector | Common |
| Burnt or damaged cable near the exhaust | Sometimes |
| Exhaust leak just before the sensor | Sometimes |
| Faulty engine computer (ECU) | Rare |

A code points to the area. Sometimes the garage only finds the real cause after that.

## How to fix it

Start with what costs least.

- 1Read all the codes. If P0141 is there too, the heater of this sensor has also failed.

- 2Check that the connector of the rear sensor is firmly in place.

- 3Look for melted spots on the cable where it runs along the exhaust.

- 4Have the voltage checked with a warm engine. It should switch between about 0.1 and 0.9 volts.

- 5If the signal stays still, fit a new sensor.

## What to ask the garage

- Which other codes are stored, and can I have the printout?

- Which measurement shows that this is the cause?

- What does an original part cost, and what does a pattern part cost?

- What will it cost if you find more? Call me before you go ahead.

## If you wait

The mixture is controlled on sensor 1. The catalytic converter test does use sensor 2. Without a good signal, that test is not reliable.

First drive with the fault

The computer stores the fault.

Second drive in a row

The engine warning light comes on.

Months of driving on

The engine runs normally. The catalytic converter is not monitored properly.

At the APK

The APK inspector measures the exhaust gases, because there is a P-code.

## What it costs

It depends on the cause. Where do the prices come from? ›

| Part | At the garage | Part only |
| --- | --- | --- |
| [Lambda sensor](https://vroomdoctor.com/nl/reparatiekosten/lambdasonde) | Garage €1162 prices, €112 to €120 | Part €792 prices, €57 to €100 |
| [Catalytic converter](https://vroomdoctor.com/nl/reparatiekosten/katalysator) | Garage €3393 prices, €329 to €600 | Part €2402 prices, €193 to €286 |

## Background

How the lambda sensors measure

How it works ›

### What the rear lambda sensor does

The lambda sensor compares the oxygen in your exhaust gas with the outside air. It turns that into a voltage. The voltage runs from 0 to 1,275 mV.

Sensor 2 sits behind the catalytic converter. With this sensor, the engine computer measures how much oxygen the catalytic converter can store. The Saab 9-4X V6 keeps the voltage of this sensor between 580 and 665 mV.

### When the computer sets the code

The Saab 9-4X V6 sets the code if the voltage of sensor 2 stays still while the sensor heater has finished warming up. The code is set within 15 seconds.

The test starts once the engine has been running for 150 seconds. If there is also a code for this sensor’s heater, such as P0141, fix that first.

### In numbers

**Sensor signal range:**

0 to 1,275 mV1

**P0140 threshold (Saab 9-4X V6):**

Voltage of sensor 2 does not change1

**Code set within:**

15 s1

**Test starts:**

After 150 s of engine running1

**Target value after the catalytic converter:**

580 to 665 mV3

**Engine warning light on:**

On the second drive in a row with the same fault4

## Questions

### Is P0140 serious?

Usually not. The rear sensor only checks your catalytic converter. The engine keeps running normally.

### Which sensor is bank 1, sensor 2?

The sensor behind the catalytic converter, on the side of cylinder 1. A 4-cylinder engine has only one bank.

### Will P0140 fail the APK (the Dutch MOT)?

Not for the code alone. Because of the P-code, the APK inspector does an exhaust gas test. You only fail if the emissions are too high.

## See also

- [P0136: Lambda sensor circuit fault (bank 1, sensor 2)](https://vroomdoctor.com/codes/p0136)

- [P0141: Lambda sensor heater circuit fault (bank 1, sensor 2)](https://vroomdoctor.com/codes/p0141)

- [P0420: Catalytic converter efficiency too low (bank 1)](https://vroomdoctor.com/codes/p0420)

- [P0130: Lambda sensor circuit fault (bank 1, sensor 1)](https://vroomdoctor.com/codes/p0130)

- [P0133: Lambda sensor slow response (bank 1, sensor 1)](https://vroomdoctor.com/codes/p0133)

- [Lambda sensor](https://vroomdoctor.com/nl/reparatiekosten/lambdasonde)

- [Catalytic converter](https://vroomdoctor.com/nl/reparatiekosten/katalysator)

- [Engine warning light](https://vroomdoctor.com/nl/waarschuwingslampjes/motorstoringslampje)

Was this helpful?

19 November 2026 · 5 sources · [In het Nederlands](https://vroomdoctor.com/nl/storingscodes/p0140)

## Sources

All sources checked on 19 November 2026.

- [Saab WIS, 9-4X 2011 V6: DTC P0134, P0140, P0154 or P0160 (factory manual)](https://saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0134-p0140-p0154-or-p0160-lf1-lfw)

- [Saab WIS, 9-4X 2011 V6: DTC P0420 or P0430 (factory manual)](https://saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0420-or-p0430-lf1-lfw)

- [Saab WIS, 9-4X 2011 V6: DTC P2096 (factory manual)](https://saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p2096)

- [Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)](https://saabwisonline.com/9-4x/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-fault-symptoms/powertrain-diagnostic-trouble-code-dtc-type-definitions)

- [RDW, APK handbook Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)](https://www.rdw.nl/-/media/apk-handboek/pdf/apk-handboek-regelgeving-januari-2022.pdf)

How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to [hallo@vroomdoctor.com](mailto:hallo@vroomdoctor.com).

## Your phone sees P0140 before you do.

Vroom Doctor is a small device that sits under your steering wheel. The app is free.

[Pre-order for €59](https://vroomdoctor.com/order)
