- How bad
- This week
- Do it yourself
- Hard, you need experienceWith experience you can replace a brake caliper yourself. Bleed the brake system properly afterwards. Brakes are safety work. If in doubt, let the garage do it.
- Lasts
- Often more than 100,000 km, sometimes the whole life of the car
Prices
Including 21% VAT, 19 November 2026. Where do they come from? ›
Garage, with labour
Middle of 2, €132 to €450.
- Vandaag Auto's19 Nov€132
- Carpardoo magazine19 Nov€450
ANWB: €100 to €350. Not counted.
Part only
Middle of 2, €46 to €62.
Without fitting. A garage often replaces more parts with it.
- mijnautoonderdelen categorie19 Nov€46
- autoonderdelen24 categorie19 Nov€62
What it does
The brake caliper presses your brake pads against the brake disc. Inside is a piston that brake fluid pushes outwards. Rust or dirt can make that piston or the guides stick.
How you notice
- Car pulls to one side when braking
- One wheel is much hotter than the rest after driving
- A burning smell at one wheel
- Grinding, or the car doesn’t coast freely
- One brake pad wears out much faster than the others
If you wait
Guide pin or piston gets stiff
The brake drags slightly. The pads on one side wear faster.
Caliper sticks
The wheel gets hot. You smell burning.
Driving on
The brake disc and other parts take extra strain. The car can pull to one side when braking.
At the APK
More than 30% difference in braking force on one axle is a fail.
Background
How it works ›
What the brake caliper does
When you press the brake pedal, the brake fluid pushes the piston in the brake caliper outwards. The caliper presses the brake pads against the brake disc and the car slows down.
Most passenger cars have floating calipers with pistons on one side. Cars with heavier brakes more often have fixed calipers with pistons on both sides.
What makes a brake caliper stick
Rust, dirt, moisture and road salt make the guide pins or the piston seize. Worn boots and seals play a part too.
Changing the brake fluid on time limits rust inside the caliper. If the housing is still good, a caliper can be reconditioned with new pistons, pins and seals.
If you keep driving on it
A sticking caliper makes the brake drag. The wheel gets hot and you smell burning. The pads on one side also wear faster, and the brake disc and other parts take extra strain. The ANWB advises against driving on.
At the APK, the difference in braking force between left and right on one axle must not be more than 30% of the highest measured value.
In numbers
- APK, difference between left and right
- At most 30% of the highest measured braking force on one axle1
- APK, braking deceleration for cars from after 2011
- At least 5.8 m/s² with at most 500 N of pedal force1
- APK, braking deceleration for cars from 1967 up to and including 2011
- At least 5.2 m/s²1
- Lifespan
- Often more than 100,000 km, sometimes the whole life of the car2
- Reconditioning
- Possible if the caliper housing is still good2
Questions
Can you keep driving with a sticking brake caliper?
No. The ANWB (the Dutch motoring club) advises against it, because the brake keeps dragging.
Do you have to replace brake calipers per axle?
Not always. Garages do assess brakes per axle, so left and right brake equally. If the caliper on the other side is old and rusty, they’re often done together.
Will a sticking brake caliper fail the APK (the Dutch MOT)?
It can. On the brake tester, the inspector measures the braking force per wheel. If one side brakes more than 30% less than the other, that’s a fail.
See also
Was this helpful?
· 2 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.