- How bad
- Within a month
- Do it yourself
- Possible, if you are handyYou can replace a drive shaft yourself, with a big socket for the axle nut and a torque wrench. A boot is trickier, because then the joint has to come off. Fitting a complete reconditioned shaft is often easier.
- Lasts
- 100,000 to 200,000 km on average
Prices
Including 21% VAT, 19 November 2026. Where do they come from? ›
Garage, with labour
Middle of 2, €119 to €1,500.
- Vandaag Auto's19 Nov€119
- Carpardoo magazine19 Nov€1,500
ANWB: €250 to €800. Not counted.
Part only
Middle of 2, €87 to €99.
Without fitting. A garage often replaces more parts with it.
- mijnautoonderdelen categorie19 Nov€87
- autoonderdelen24 categorie19 Nov€99
What it does
It carries the power from the gearbox to your wheels. At each end there’s a CV joint, so the wheel can steer and move with the suspension. A rubber boot keeps the grease in and the dirt out.
How you notice
- Ticking or clicking in tight bends, especially when accelerating
- Grease on the inside of the rim or on the suspension
- Shaking when pulling away, gone when you drive gently
- A clunk when you lift off the accelerator or press it again
If you wait
Boot tears
The grease leaks out. Dirt and moisture get into the CV joint. You’ll fail the APK.
CV joint wears
You hear ticking or clicking in sharp bends.
Shaking when accelerating
The shaft or the CV joint is more worn. Have it checked as soon as possible.
Background
How it works ›
What the drive shaft does
The drive shaft carries the engine’s power through the gearbox and the differential to the driven wheels. On a front-wheel-drive car, the drive has to keep working while you steer. The CV joint makes that movement possible.
Each CV joint has a rubber dust cover around it, also called a boot. It keeps the grease in and dirt and moisture out.
What wears a drive shaft out
Accelerating, bends and bad roads put constant strain on the shaft. The CV joints and the boots are the most prone to wear. A drive shaft lasts 100,000 to 200,000 km on average.
If the boot is damaged, the grease escapes. Dirt and moisture get in. The CV joint then often wears faster.
If you keep driving on it
A worn CV joint ticks or clicks in sharp bends. Shaking when pulling away can also point to a worn shaft or CV joint. The ANWB advises having the car checked as soon as possible then.
Sometimes a new CV joint or boot is enough. At the APK the boots must be properly attached and still seal.
In numbers
Questions
How can you tell a drive shaft is broken?
By ticking in a tight bend while you accelerate, like when pulling out of a parking space. That points to the outer CV joint.
Will I pass the APK (the Dutch MOT) with a torn boot?
No. According to the RDW’s APK manual, drive shaft boots must be firmly attached and still seal.
Can I keep driving with a ticking drive shaft?
Driving gently to the garage is fine. The ticking points to a worn CV joint. Have it repaired within a month.
Is a torn boot a big deal?
If you replace it soon, it’s a small job. If you keep driving on it for a long time, dirt and moisture get into the joint. It then wears faster.
See also
Was this helpful?
· 2 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.