- How bad
- No rush
- Do it yourself
- Hard, you need experienceGlow plugs are often baked in. Loosen them with a warm engine and little force. If one snaps, the garage has to drill it out.
Prices
Including 21% VAT, 19 November 2026. Where do they come from? ›
Part only
Middle of 2, €12 to €14.
Without fitting. A garage often replaces more parts with it.
- mijnautoonderdelen19 Nov€12
- autoonderdelen2419 Nov€14
What it does
Glow plugs heat the combustion chamber of a diesel before starting. A cold diesel then ignites more easily. After starting they keep glowing for up to 3 minutes. That way the engine runs more smoothly and smokes less.
How you notice
- Diesel starts badly when it’s cold
- Glow plug light flashes or stays on
- White smoke and rough running after a cold start
- Fault code for a glow plug on one cylinder
When to replace it
There’s no fixed interval. Check your service book.
If you wait
How long you can keep driving with a broken glow plug mostly depends on the temperature outside.
Summer
The engine still starts. At most you notice more emissions and some knocking on a cold start.
First frost
The engine starts with difficulty and smokes. Or it doesn’t start at all.
Stuck glow plug relay
The glow plugs get power for too long. They overheat and can swell or crack.
Background
How it works ›
What a glow plug does
A diesel ignites without a spark. The air is compressed to 30 to 55 bar and gets 700 to 900 °C hot in the process.
On a cold start that’s not enough. The glow plug heats the combustion chamber and reaches more than 1,000 °C within a few seconds.
After the start it keeps glowing for up to 3 minutes, or until the coolant is 70 °C. The engine then runs more smoothly and smokes less. On newer diesels the after-glow sometimes stays on while the engine runs, for example in a traffic jam.
How glow plugs wear
There’s no fixed replacement interval. The lifespan depends on how many times they heat up, from cold starts and diesel particulate filter regenerations.
A glow plug works between 850 and 1,100 °C. If it gets power for too long, for example from a stuck relay, it swells or cracks.
Injection timing that’s too early or a dripping injector can make the glow tube melt. Fix that cause too.
In numbers
- Diesel compression pressure
- 30 to 55 bar1
- Air temperature after compression
- 700 to 900 °C1
- Glow plug working temperature
- 850 to 1,100 °C2
- Pre-glow time with an after-glowing plug
- about 2 seconds at 0 °C, 7 seconds at -10 °C1
- After-glow
- up to 3 minutes, or until the coolant is 70 °C1
- Replacement interval
- no fixed interval, depends on the number of heat-up cycles2
Questions
Can you drive with a broken glow plug?
Yes. In summer you often don’t notice anything. In winter the engine starts worse.
Do you have to replace all the glow plugs at once?
Usually yes, because they’re about the same age. Any plug can snap when you loosen it, though.
How do you test a glow plug?
Measure the resistance with a multimeter. No continuity? Then it’s broken.
See also
Was this helpful?
· 3 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.