- How bad
- Within a month
- Read it yourself
- Yes, with an OBD reader
- Garage
- €27 to €55 to read it
What the light does
- Stays on
- ABS is off. Normal braking still works.
- Together with the red brake light
- Brake force distribution may be off too. Don’t drive further than you need to.
- Comes on and goes off
- Often a sensor or cable at a wheel that loses contact now and then.
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty ABS sensor at a wheel | Common |
| Damaged cable or plug to the sensor | Common |
| Dirty or cracked sensor ring | Sometimes |
| Low battery voltage · €118 | Sometimes |
| Faulty ABS pump or module | Rare |
How to deal with it
- 1Switch the car off and on again. Light off? Drive calmly and still get it read.
- 2Get the fault read with a scanner that reads ABS. It tells you which wheel it is.
- 3Check the cable and plug at that wheel for breaks or dirt.
- 4Replace the ABS sensor.
- 5ABS module broken? Reconditioning is often cheaper than new.
If you keep driving
Light comes on
ABS is off.
In an emergency stop
Wheels can lock. Then you can’t steer.
Red brake light comes on too
Stop the car and check the brake fluid.
At the APK
First registered 2018 or later: fail. An older car gets a repair advice.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Battery | Garage €118 | Part none |
Background
How it works ›
How ABS works
Sensors at the wheels watch whether a wheel is about to lock. If so, ABS briefly lowers the brake pressure on that wheel and builds it up again once the wheel has grip. That repeats quickly, so you can keep steering in an emergency stop.
You feel it as vibration in the brake pedal. Don’t let go of the pedal then. Keep it pressed firmly.
What the light means
With the ignition on, the light shows for about 3 seconds. If it stays on, ABS has a fault.
The car still brakes normally, but ABS won’t step in during an emergency stop. Peugeot says to drive carefully at moderate speed and go to a workshop.
If the red brake light is also on, there may be too little brake fluid or brake force distribution isn’t working. Stop the car then.
Cause, costs and APK
The wheel sensors are the most sensitive part. Dirt, rust, road salt and drying out affect them. Repairing or replacing a sensor usually costs €200 to €300 according to the ANWB. A repair to the ABS pump can cost €1,200 according to the ANWB.
Since 20 May 2018 the APK looks at the ABS warning light. For cars first registered in 2018 or later, a light that stays on means a fail. Older cars get a repair advice point on the report.
In numbers
Questions
Will I fail the APK (the Dutch MOT) with the ABS light on?
If your car was first registered in 2018 or later, yes. On an older car you get a repair advice point and you don’t fail. Get it fixed before the inspection.
Can I still brake safely without ABS?
Yes, the brakes work. If you brake hard, the wheels can lock. Then you can’t steer. Keep more distance.
What does replacing an ABS sensor cost?
Usually €200 to €300, says the ANWB. The ABS pump costs more, up to around €1,200.
See also
Was this helpful?
· 5 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.