Skip to content

P0014: Camshaft B over-advanced or system performance (bank 1)

Your exhaust camshaft (camshaft B) is further advanced than the computer asks for, on bank 1. Usually the oil or the solenoid valve.

Within a monthYou can keep driving if the engine runs smoothly. Have it fixed within a month.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
€89 to €1,000

What you notice

  • The engine warning light is on
  • Rough idle
  • Hard starting
  • Higher fuel consumption

What usually causes it

CauseLikelihood
Too little, old or wrong engine oilCommon
Faulty exhaust camshaft solenoid valveCommon
Faulty actuator on the camshaftSometimes
Stretched timing chain · €712Sometimes
Faulty camshaft position sensor B · €89Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check the oil level. If the oil is old, change it.
  2. 2Check that the connector of solenoid valve B is secure.
  3. 3Have the solenoid valve tested. If it sticks, fit a new one.
  4. 4Does the code come back? Then have the actuator and the timing checked.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

The exhaust camshaft is also adjusted with engine oil. Old or wrong oil causes the same problems here. According to the ANWB (the Dutch motoring club), oil quality also largely decides how long a timing chain lasts.

After two drives in a row with the fault, the engine warning light comes on. If you hear rattling after a cold start, have the chain checked too.

  1. First drive with the fault

    The computer stores the fault. The light stays off for now.

  2. Second drive in a row

    The light comes on.

  3. Weeks of driving on

    Check your oil level. With too little or the wrong oil, the actuator is poorly controlled.

  4. Rattling on a cold start

    Possibly a stretched chain. Have it checked before you drive further.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Timing chainGarage €712Part €100
Camshaft position sensorGarage €89Part €24

Background

CamshaftsCrankshaftTensionerWater pumpTiming beltTiming marks keep crankshaft and camshaft in step
How the crankshaft and camshaft run together
How it works ›

How variable valve timing works

The engine computer can turn each camshaft a few degrees relative to the crankshaft while you drive. That is done with oil pressure. A solenoid valve decides how much oil the actuator gets. The computer controls that valve with a pulsed signal.

P0014 is about the exhaust camshaft on bank 1. Most makes call it camshaft B.

When the computer sets the code

In the factory manual for the Saab 9-4X V6, the computer compares the requested and the actual position. If they differ by more than 5 degrees for longer than 10 seconds, P0014 follows. The test only runs when the requested position has stayed still for one second.

If work was done on the engine recently, check that the camshaft, solenoid valve, actuator and timing chain are fitted correctly. According to the same manual, a fitting error also gives this code.

In numbers

Solenoid valve control
Pulse width, the valve controls the oil flow to the actuator1
Deviation limit (Saab 9-4X V6)
More than 5 degrees, for longer than 10 s1
Test condition
Requested position changes less than 4.5 degrees in 1 s1
Battery voltage during test
11 to 32 V1
Engine warning light on
On the second drive in a row with the same fault2
Chain stretched too far
Can happen at around 200,000 km or more3
Engine warning light goes off
After 3 drives in a row without the fault4

Questions

Is camshaft B always the exhaust camshaft?

On most makes, yes. The workshop manual for your car will tell you for sure.

What does fixing P0014 cost?

That depends on the cause. Fresh oil is the cheapest. A new solenoid valve costs more. Garages charge €75 to €103 per hour.

Will P0014 fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the usual way. Only if they are too high does the car fail the APK. The rules for each fuel type are in the APK guide.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0011, P0014, P0021 or P0024 (factory manual)
  2. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  3. ANWB, Which is better: timing belt or chain? (in Dutch)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK handbook regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.