Skip to content

P0113: Intake air temperature sensor 1: signal too high (bank 1)

Your intake air sensor reports ice-cold air because of a signal that is too high. Usually it is a loose connector or a broken wire, often after a new air filter.

No rushYou can keep driving. Fix it when it suits you.

How bad
No rush
Do it yourself
Yes, you can do it yourself
Usually
Loose connector, often after a new air filter

What you notice

  • The engine warning light is on
  • Hard starting
  • Slightly higher fuel consumption

What usually causes it

CauseLikelihood
Loose connector, often after a new air filterCommon
Broken wireSometimes
Faulty sensor or mass airflow sensor (with the sensor inside)Sometimes
Corroded contactsSometimes

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check that the connector on the sensor or mass airflow sensor is properly clicked in.
  2. 2Check the wires to the sensor for breaks.
  3. 3Look at the intake temperature in the app. If it shows around -40 °C, the circuit is open.
  4. 4If the wires are fine, fit a new sensor.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

With this code, the Saab switches on the radiator fans. The computer works with a substitute value. The engine warning light comes on during the second drive in a row.

  1. First drive with the fault

    The computer stores the fault. It works with a substitute value.

  2. Second drive in a row

    The light comes on.

  3. Weeks of driving on

    The engine usually runs normally. At the APK, a standard exhaust gas test follows.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Mass airflow sensorGarage nonePart €72

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

How the intake air sensor works

The intake air temperature sensor is a resistor that changes with temperature. On the Saab 9-4X V6 it sits in the mass airflow sensor. The engine computer puts 5 V on the signal wire and reads how much voltage is left.

To the computer, a high signal means cold air. With a broken wire, the computer therefore sees extremely cold air. A code reader then shows -40 °C.

When the computer sets P0113

In the factory manual for the Saab 9-4X V6, the computer sets P0113 when the signal shows colder than -60 °C for more than 7 seconds. It never gets that cold in the Netherlands. So the cause is in the circuit.

The manual lists a broken earth wire of the mass airflow sensor and a short circuit with the mass airflow sensor wire as causes. A loose connector after replacing the air filter gives the same picture.

In numbers

Sensor supply
5 V from the engine computer1
P0113 limit (Saab 9-4X V6)
Colder than -60 °C, for more than 7 s1
Reading with an open circuit
-40 °C1
Computer response (Saab 9-4X V6)
Radiator fans on1
Engine warning light on
On the second drive in a row with the same fault2

Questions

Why do I see -40 degrees for the intake air?

That is the default value for an open circuit. First look for a loose connector or a broken wire.

Can I fix P0113 myself?

Often, yes. Usually the connector was not refitted properly after a service.

Will P0113 make my car fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the usual way. You only fail if they are too high. The rules for each fuel type are in the APK guide.

See also

Was this helpful?

· 3 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0112, P0113 or P0114 (factory manual)
  2. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  3. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.