Skip to content

P0110: Intake air temperature sensor 1: circuit fault (bank 1)

The sensor that measures the temperature of your intake air reports a fault. Usually it is a loose connector or a faulty sensor.

No rushYou can keep driving. Fix it when it suits you.

How bad
No rush
Do it yourself
Yes, you can do it yourself
Usually
Loose or corroded connector

What you notice

  • The engine warning light is on
  • Hard starting in the cold
  • Slightly higher fuel consumption

What usually causes it

CauseLikelihood
Loose or corroded connectorCommon
Faulty sensor, often inside the mass airflow sensorCommon
Damaged wiringSometimes
Faulty engine computer (ECU)Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Find the sensor: in the mass airflow sensor, the air duct or the intake manifold.
  2. 2Check that the connector is firmly attached. Especially if the air filter was just replaced.
  3. 3With a cold engine, compare the intake temperature in the app with the outside temperature.
  4. 4If the value is wrong, fit a new sensor or mass airflow sensor.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

With these codes, the Saab switches on the radiator fans.

HELLA lists poor starting, less power and higher fuel consumption as complaints. Causes are a broken cable, a short circuit, damage and a dirty sensor tip.

  1. First drive with the fault

    The computer stores the fault. The Saab switches on the radiator fans.

  2. Second drive in a row

    The light comes on.

  3. Weeks of driving on

    Poor starting, less power or higher fuel consumption are possible.

  4. At the APK

    The APK inspector measures the exhaust gases. If they are too high, your car fails the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Mass airflow sensorGarage nonePart €72

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

How the intake air sensor works

The sensor is a resistor that changes with temperature. The engine computer puts 5 V on the signal wire and reads the voltage back. On the Saab 9-4X V6, the sensor sits in the mass airflow sensor.

HELLA gives a guide value of 2.0 to 6 kOhm at 25 °C and about 300 ohms at 80 °C.

When the computer sets the code

P0110 is the general code for the circuit. The Saab 9-4X V6 splits the fault up. A signal that shows warmer than 149 °C for more than 7 seconds is P0112. Colder than -60 °C is P0113. If the signal jumps back and forth for more than 4 seconds, it is P0114.

In numbers

Sensor supply
5 V from the engine computer1
Resistance at 25 °C
2.0 to 6 kOhm2
Resistance at 80 °C
About 300 ohms2
Too warm limit (Saab 9-4X V6)
Above 149 °C, for more than 7 s1
Too cold limit (Saab 9-4X V6)
Below -60 °C, for more than 7 s1
Engine warning light on
On the second drive in a row with the same fault3

Questions

Is P0110 serious?

No. The engine works with a substitute value. It usually keeps running normally.

What does it cost to fix P0110?

A separate sensor is cheaper than a mass airflow sensor. If it sits inside the mass airflow sensor, garages charge around €175.

Will P0110 make my car fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the usual way. You only fail if they are too high. The rules for each fuel type are in the APK guide. This fault usually has little effect on emissions.

See also

Was this helpful?

· 4 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0112, P0113 or P0114 (factory manual)
  2. HELLA Tech World, Check intake air temperature sensor
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.