Skip to content

P0236: Boost pressure sensor A: range or performance

Your turbo’s boost pressure sensor is giving a value that does not add up. Usually it is a leaking pressure hose or a dirty sensor.

Within a monthYou can keep driving gently. Have it looked at within a month, as the car can go into limp mode.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
€639 to €2,250

What you notice

  • The engine warning light is on
  • Car goes into limp mode
  • Less power
  • Hissing when you accelerate

What usually causes it

CauseLikelihood
Loose or cracked turbo hoseCommon
Dirty or faulty boost pressure sensorCommon
Poor connector or wiringSometimes
Turbo control is stuck (wastegate or vanes) · €960Sometimes
Faulty turbo · €960Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Read all the codes. Look out for P0299 or P0234 alongside it.
  2. 2Check all turbo hoses and clamps for cracks and oil.
  3. 3Remove the boost pressure sensor. Clean it with electronics cleaner.
  4. 4During a test drive, have the requested and the actual boost pressure compared.
  5. 5If the sensor is off, replace it. Only then have the turbo control checked.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

On the Saab 9-5 diesel, the engine computer controls the turbo’s boost pressure based on the signal from this sensor. With a wrong value, the boost pressure is no longer correct.

The manual has you look for leaks in the pressure hoses with soapy water from a plant sprayer.

  1. First drive with the fault

    The computer stores the fault.

  2. Second drive in a row

    The engine warning light comes on.

  3. Weeks of driving on

    The boost pressure is not controlled properly.

  4. At the APK

    Because of the P code, an exhaust gas test follows. If a diesel particulate filter (DPF) is registered for the number plate, the APK (the Dutch MOT) inspector always measures with a particle counter.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
TurboGarage €960Part €668

Background

Fresh airCompressorTurbineIntercoolerIntake manifoldEngineExhaust manifoldTo exhaust
How the turbo works
How it works ›

What the boost pressure sensor measures

The sensor sits between the turbo and the throttle. It measures the pressure of the compressed air. In the Saab 9-4X 2.8 turbo, it also contains an air temperature sensor.

With the ignition on and the engine off, it measures the outside air pressure. At idle it measures that too. At full throttle, the pressure in this Saab rises to almost 240 kPa.

When the computer sets the code

The computer checks whether the value is plausible. The Saab 9-4X 2.8 turbo does this at idle, below 1,120 revs per minute and with the throttle less than 10 percent open. The boost pressure sensor should then read roughly the outside air pressure.

The computer compares the sensor with its own air pressure sensor. If the difference is too large, up or down, the code follows. The air pressure sensor is inside the engine computer. It measures through an opening in the housing. That opening must not be blocked.

In numbers

Test runs (Saab 9-4X 2.8 turbo)
Below 1,120 rpm, throttle less than 10 % open1
Comparison
Boost pressure sensor against the air pressure sensor in the engine computer1
Highest pressure at full throttle
Almost 240 kPa1
Pressure with the engine off
Equal to the outside air pressure1
Engine warning light on
On the second drive in a row with the same fault3
Engine warning light goes off
After 3 drives in a row without a fault4

Questions

What does a boost pressure sensor cost?

That depends on your engine. Garages charge €75 to €103 per hour.

Can P0236 damage the turbo?

The sensor itself cannot. A leaking hose does make the turbo work harder. So do not leave it for months.

Will I fail the APK with P0236?

Not on the code alone. Because of the P code, the APK (the Dutch MOT) inspector does a standard exhaust gas test or particulate measurement.

See also

Was this helpful?

· 6 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 2.8 turbo: DTC P0236, P0237 or P0238 (factory manual)
  2. Saab WIS, 9-5 2011 diesel: Air Intake System Description (factory manual)
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK handbook Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
  6. RDW, APK Keurmeester no. 110 (September 2025): when is a particulate measurement required? (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.