Skip to content

P0305: Cylinder 5 misfire detected

The engine computer sees that cylinder 5 is misfiring. The mixture in that cylinder is not burning properly. Usually it is the spark plug or the ignition coil of that cylinder.

This weekStop as soon as it is safe if the engine warning light flashes. If it is on steadily, you can drive calmly to the garage, this week.

How bad
This week
Do it yourself
Yes, you can do it yourself
Usually
Worn or dirty spark plug in cylinder 5
Garage
usually €115

What you notice

  • The engine shakes or runs rough, especially at idle
  • Judders when pulling away
  • Less power
  • The engine warning light is on or flashing
  • You use more fuel

What usually causes it

CauseLikelihood
Worn or dirty spark plug in cylinder 5 · €115Common
Faulty ignition coil on cylinder 5 · €124Common
Injector of cylinder 5 is leaking, sticking or spraying too littleSometimes
Air leak at the intake port of cylinder 5Sometimes
Low compression in cylinder 5, from the valves or piston ringsRare
Leaking head gasket at cylinder 5, often with coolant loss · €649Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1If the engine warning light flashes, stop and switch off the engine. Unburnt fuel can quickly damage your catalytic converter.
  2. 2Read all the codes. If only P0305 is stored, the fault is almost certainly in cylinder 5 itself. This code only occurs on engines with 5 or more cylinders.
  3. 3Swap the ignition coil of cylinder 5 with the one from cylinder 4. Clear the code. If the fault moves with it, it is the coil.
  4. 4Unscrew the spark plug of cylinder 5. Look for a worn electrode, oil, soot or white deposits.
  5. 5If the spark plugs are at the end of their interval, replace them as a set.
  6. 6After the repair, check the misfire counter for this cylinder in the app. If it stays at 0 while you drive, the fault is fixed.
  7. 7If the spark plug and coil are fine, have the injector of cylinder 5 tested. Then the compression.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What does an original part cost, and what does a pattern part cost?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

According to the ANWB, incomplete combustion, for example from worn spark plugs, is a common cause of a failed catalytic converter. According to the ANWB, a new catalytic converter costs €500 to €1,000.

  1. Straight away

    With a flashing engine warning light, the catalytic converter can be damaged quickly.

  2. First drive with light misfire

    The computer stores the fault. The light stays off for now.

  3. Second drive in a row

    The engine warning light is on steadily.

  4. Weeks of driving on

    Unburnt fuel puts strain on the catalytic converter. It can fail.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Spark plugsGarage €115Part €7
Ignition coilGarage €124Part €48
InjectorsGarage nonePart €117
Head gasketGarage €649Part €83
Catalytic converterGarage €339Part €240

Background

+−BatteryEngine managementIgnition coilSpark plugCylinder headSparkPiston
How the ignition works
How it works ›

How the engine computer measures misfire

Every combustion gives the crankshaft a push. If one is missing, the crankshaft turns a little slower for a moment. The engine computer sees this through the crankshaft position sensor. Through the camshaft position sensor it knows which cylinder was firing.

P0305 means the computer sees misfire on cylinder 5. If it can identify the cylinder, it sets the code for that cylinder. It then also switches off the injector of that cylinder.

The European OBD rules require the computer to monitor misfire up to a maximum of 4,500 rpm. In the factory manual for the Saab 9-4X V6, the computer counts in blocks of 1,000 crankshaft revolutions.

Why the light flashes

With heavy misfire, unburnt fuel enters the catalytic converter. It gets too hot and is damaged. The engine warning light then flashes, on the Saab 9-4X once per second. The computer then tries the switched-off injector again every 30 seconds.

If the light is on steadily, the misfire is enough to raise emissions. The light comes on when the fault occurs on two drives in a row.

Finding the cause

The spark plug makes the spark, with about 30,000 V from the ignition coil. A worn spark plug makes the coil work harder. The replacement schedule differs per car. The ANWB (the Dutch motoring club) gives 4 years or 60,000 km for a VW Golf, and about 100,000 km for an iridium spark plug.

The Saab manual also lists causes outside the engine. An unbalanced wheel, uneven brake discs or a rough road can look like misfire. High resistance in the wire to an injector can cause misfire without an injector code.

In numbers

Monitored engine speed range (EU)
Up to a maximum of 4,500 rpm1
Counting blocks
1,000 revolutions for emissions, 200 for catalytic converter damage2
Test range (Saab 9-4X V6)
450 to 6,600 rpm3
Flashing engine warning light
1 time per second with misfire that damages the catalytic converter4
Steady engine warning light
On the second drive in a row with the same fault4
Voltage at the spark plug
About 30,000 V5
Four new spark plugs (ANWB)
€150 to €200 for a mid-size car5
New catalytic converter (ANWB)
€500 to €1,0006

Questions

Can I keep driving with P0305?

A calm drive to the garage is fine, as long as the light is on steadily. Stop as soon as it flashes. Unburnt fuel can then overheat your catalytic converter.

How do I know whether it is the ignition coil or the spark plug of cylinder 5?

Swap the ignition coil of cylinder 5 with the one from cylinder 4 and clear the code. If the fault moves to cylinder 4, the coil is faulty. If it stays on cylinder 5, look at the spark plug. Then at the injector.

Will I pass the APK (the Dutch MOT) with P0305?

Not on the code alone. With a P code in memory, the APK inspector measures the exhaust gases. You only fail the APK if that reading is too high. The rules for each fuel type are in the APK guide.

Why does P0305 keep coming back after new spark plugs?

Check that the spark plugs are the right type and are tightened properly. Also check that the ignition coil clicks firmly into place. If it continues, the cause is usually the coil, the injector or the compression of that cylinder.

See also

Show 3 more ›

Was this helpful?

· 7 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  2. California Code of Regulations, title 13, section 1968.2 (OBD II requirements)
  3. Saab WIS, 9-4X 2011 V6: DTC P0300 to P0306 (factory manual)
  4. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  5. ANWB, Spark plug (in Dutch)
  6. ANWB, What is a catalytic converter and when does it need replacing? (in Dutch)
  7. RDW, APK handbook Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.