- How bad
- Within a month
- Do it yourself
- Possible, if you are handy
- Usually
- Catalytic converter worn or damaged
- Garage
- usually €339
What you notice
- The engine warning light is on, and often you notice nothing else
- Sometimes a rotten-egg smell from the exhaust
- Sometimes less pulling power if the catalytic converter gets blocked
- Higher fuel consumption
What usually causes it
| Cause | Likelihood |
|---|---|
| Catalytic converter worn or damaged · €339 | Common |
| Lambda sensor behind the catalytic converter reads incorrectly · €116 | Common |
| Exhaust leak before or near the lambda sensor | Sometimes |
| Engine misfires or runs too rich (catalytic converter gets too hot) · €115 | Sometimes |
| Lambda sensor in front of the catalytic converter reacts too slowly · €116 | Sometimes |
| Oil or coolant consumption contaminates the catalytic converter · €649 | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Look at other codes. Is there a misfire or mixture code, such as P0300 or P0171? Fix that first.
- 2During a drive, check in the app how often each cylinder misfires. Also check how much fuel trim the computer is applying. A misfire or a rich mixture also quickly ruins a new catalytic converter.
- 3With the engine cold, listen at the exhaust manifold and the flex pipe for ticking or blowing. A leak gives false readings.
- 4Have the garage compare both lambda sensors. If the rear one swings as wildly as the front one, the catalytic converter is bad.
- 5Does the rear sensor react slowly or oddly? Replace it. Garage: €112 to €120, fitted.
- 6If the sensors are fine, replace the catalytic converter. Garage: usually €470, fitted (€329 to €750).
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What does an original part cost, and what does a pattern part cost?
- What will it cost if you find more? Call me before you go ahead.
Not sure if it is the catalytic converter or the lambda sensor? Read catalytic converter or lambda sensor (in Dutch).
If you wait
According to the ANWB (the Dutch motoring club), a catalytic converter lasts at least 10 years or 150,000 km with normal use. If it fails earlier, incomplete combustion is usually the cause. If that cause remains, a new catalytic converter will be damaged too.
At the APK, a stored P code leads to a standard exhaust gas test. A worn catalytic converter can make the car fail the APK on that test.
First drive with the fault
The computer stores the code. On the Saab 9-4X V6, P0420 is a type A code. The engine warning light then comes on straight away.
Weeks of driving on
The car drives normally. More CO, hydrocarbons and NOx pass through the catalytic converter.
With misfires or mixture faults
The catalytic converter deteriorates further, and so does a new one.
At the APK
With a P code stored, the APK inspector measures the exhaust gases. If they are too high, you fail the APK.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Catalytic converter | Garage €339 | Part €240 |
| Lambda sensor | Garage €116 | Part €79 |
| Spark plugs | Garage €115 | Part €7 |
| Head gasket | Garage €649 | Part €83 |
Background
How it works ›
How the engine computer tests the catalytic converter
The catalytic converter turns hydrocarbons, CO and NOx into water vapour, CO2 and nitrogen. It also stores oxygen. Behind the catalytic converter sits a second lambda sensor. With it, the engine computer measures how much oxygen the converter can still store.
On the Saab 9-4X V6, the engine idles for this test, with a warm catalytic converter. The computer briefly makes the mixture richer and then leaner again. A good catalytic converter damps that swing, so the sensor behind the converter reacts slowly. If that sensor reacts almost as fast as the sensor in front of it, the storage is too small and the computer sets P0420.
Why it is often not the catalytic converter itself
The catalytic converter test only runs if no codes are stored for misfire, mixture or lambda sensors. If there is such a code, fix it first.
According to the same manual, a catalytic converter deteriorates from misfires, oil or coolant consumption, ignition timing that is too late, a weak spark and a mixture that is too lean or too rich. Bosch also names a faulty rear sensor, poor wiring and exhaust leaks as causes of a false reading.
In numbers
- Test runs at (Saab 9-4X V6)
- Idle, coolant 40 to 127 °C, catalytic converter 450 to 850 °C1
- Tests per drive (Saab 9-4X V6)
- 1 per idle period, up to 81
- Front lambda sensor signal
- Swings between about 0.1 and 0.9 V3
- Catalytic converter lifespan (ANWB)
- At least 10 years or 150,000 km4
- New catalytic converter (ANWB)
- €500 to €1,000, depending on the car4
- Engine warning light goes off
- After 3 drives in a row without the fault5
- Code is cleared from memory
- After 40 warm-up cycles without the fault5
Questions
Will my car fail the APK (the Dutch MOT) on P0420?
Not on the code alone. If a P code is stored in the memory, the APK inspector measures the exhaust gases. You only fail the APK if that measurement is too high. The rules per fuel type are in the APK guide.
Can I clear P0420?
Yes, but it comes back as soon as the computer tests the catalytic converter again. Usually within a few drives.
Does a catalytic converter cleaner from a bottle help?
Sometimes a little, with light fouling. It will not repair a worn or melted catalytic converter.
What is the difference between P0420 and P0430?
P0420 is bank 1, the side with cylinder 1. P0430 is the same fault on bank 2. That only exists on V engines and boxer engines.
See also
- P0430: Catalytic converter efficiency too low (bank 2)
- P0421: Warm-up catalytic converter efficiency too low (bank 1)
- P0136: Lambda sensor circuit fault (bank 1, sensor 2)
- P0141: Lambda sensor heater circuit fault (bank 1, sensor 2)
- P0300: Random or multiple cylinder misfire
- P0171: Too little petrol (bank 1)
- P2096: Post-catalyst fuel trim too lean (bank 1)
- P2097: Post-catalyst fuel trim too rich (bank 1)
Was this helpful?
· 6 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
- Saab WIS, 9-4X 2011 V6: DTC P0420 or P0430 (factory manual)
- Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
- Bosch, Checking the signal of lambda sensors (workshop sheet) (in Dutch)
- ANWB, What is a catalytic converter and when does it need replacing? (in Dutch)
- UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
- RDW, APK handbook Regulations, article 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.