Skip to content

P0380: Glow plugs, circuit A fault

There is a fault in the circuit of your glow plugs. Your diesel then starts poorly when it is cold. Usually it is a faulty glow plug, sometimes the glow plug relay.

Within a monthYou can keep driving. Have it fixed within a month, especially before winter.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
Depends on the cause

What you notice

  • Hard to start when it is cold
  • White smoke and rough running just after a cold start
  • The glow plug light flashes or stays on
  • Warm starts usually go fine

What usually causes it

CauseLikelihood
One or more faulty glow plugsCommon
Faulty glow plug relay or glow plug control unitSometimes
Loose or corroded connector on a glow plugSometimes
Damaged wire to the glow plugsSometimes
Blown fuse in the glow plug systemRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check the fuse for the glow plug system.
  2. 2Are all the connectors on the glow plugs secure?
  3. 3Measure the resistance of each glow plug with a multimeter. If it reads infinite, that plug has burnt out.
  4. 4Have the glow plug relay or the glow plug control unit tested.
  5. 5Have the glow plugs replaced with the engine warm. They can seize and snap off. That gets expensive.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

On a Saab, P0380 is a type C code. The engine warning light stays off and the code is only stored in memory.

After starting, the Saab keeps the glow plugs on for a short while. That limits white smoke and rough idling. Bosch also lists helping to burn the diesel particulate filter (DPF) clean as a task of modern glow plugs.

  1. Code appears

    The computer stores the fault. On a Saab the engine warning light stays off.

  2. Cold weather

    The diesel starts less easily. After starting it may give off white smoke.

  3. At the APK (the Dutch MOT)

    If the car’s registration lists a DPF, the APK inspector does not read the OBD. They measure with a particle counter.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Glow plugsGarage nonePart €13

Background

BatteryGlow plug relayGlow plugGlow tipInjectorPistonCombustion chamber
How the glow plugs work
How it works ›

How glow plug preheat works

A diesel ignites its fuel with the heat of compressed air. In a cold engine, that heat leaks away into the block. Glow plugs heat the combustion chamber before and during starting.

In the Saab 9-5 diesel, a separate module controls each glow plug individually. The plugs run on 4.4 V. At room temperature they stay on for 2 seconds. After that they are pulsed for another 2 seconds. In the cold this takes longer.

When the computer sets the code

The engine computer controls the glow plug module with a pulsed signal. The Saab 9-5 diesel sets P0380 when it sees an open circuit or a short circuit on that control wire for longer than half a second. The test runs once per drive, at 9 to 16 V.

On a Saab, a fault at a single glow plug gets its own code: P0671 to P0674 for cylinders 1 to 4.

In numbers

Glow plug voltage (Saab 9-5 diesel)
4.4 V2
Glow time at room temperature
2 s on, then 2 s pulsed2
Glow plug light at a cold start
1 s2
P0380 threshold (Saab 9-5 diesel)
Fault on the control wire for longer than 0.5 s1
Engine warning light (Saab 9-5 diesel)
Stays off, type C1
Bosch DuraSpeed heat-up time
Less than 2 s4

Questions

Can I keep driving with P0380?

Yes. Once the engine is running, it no longer needs the glow plugs. Only cold starts get harder.

Why is the glow plug light flashing?

On many diesels, including VW models, the glow plug light flashes when an engine fault is stored. Have the codes read out then.

Should I replace all the glow plugs at once?

Usually yes, if they are the same age. The labour is largely the same. The others often follow soon.

What does replacing glow plugs cost?

A glow plug costs €12 to €14 each. Labour comes on top. If one snaps off in the cylinder head, drilling it out costs more.

See also

Was this helpful?

· 6 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-5 2011 diesel: DTC P0380, P0383 or P0384 (factory manual)
  2. Saab WIS, 9-5 2011 diesel: Glow Plug System Description (factory manual)
  3. Saab WIS, 9-5 2011 diesel: DTC P0671 to P0674 (factory manual)
  4. Bosch, Automotive Insiders: Bosch glow plugs (workshop sheet) (in Dutch)
  5. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  6. RDW, APK Keurmeester no. 110 (September 2025): when is a soot measurement required? (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.