Skip to content

P0440: Fault in the fuel tank vapour system

The system that captures petrol vapour from your tank has a fault. Usually the fuel cap, a leaking hose or a faulty valve.

No rushYou can keep driving. Fix it when it suits you.

How bad
No rush
Do it yourself
Yes, you can do it yourself
Usually
Fuel cap does not close properly, or the rubber seal is worn

What you notice

  • The engine warning light is on
  • Sometimes a faint smell of petrol around the car
  • Otherwise the car drives normally

What usually causes it

CauseLikelihood
Fuel cap does not close properly, or the rubber seal is wornCommon
Leaking hose in the vapour systemCommon
Vent valve or purge valve of the charcoal canister faultySometimes
Charcoal canister cracked or saturatedRare
Leak detection pump faultyRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Unscrew the fuel cap and tighten it again until it clicks. Is the rubber seal intact?
  2. 2Clear the code. Then drive for a few days, because the system does not test itself on every drive.
  3. 3Cracks in the seal? Then fit a new fuel cap. It costs €21 to €25.
  4. 4Have the garage do a smoke test. That way they find small leaks in hoses.
  5. 5Replace the faulty valve or the charcoal canister.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

The manual starts with the fuel cap: loose, missing, damaged or the wrong one. The cap has a sealing ring and a vacuum valve.

The leak tests only run on a cold start or after a drive. That is why, after a repair, it takes a while before the light goes off.

  1. First failed test

    The computer stores the fault.

  2. Weeks of driving on

    Usually you notice nothing. Petrol vapour escapes.

  3. At the APK

    With a P code stored, the APK inspector measures the exhaust gases in the usual way.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Fuel capGarage nonePart €23

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

What the vapour system does

Petrol evaporates in the tank. The vapour system captures that vapour in a canister of activated charcoal. When the engine is running, the engine computer opens the purge valve. The engine then draws fresh air through the canister and burns the vapour.

For the leak tests, the computer closes the canister’s vent valve. A pressure sensor on the tank shows whether the system is sealed.

Which tests the computer runs

P0440 is the general code for the vapour system. On a cold start, the Saab 9-4X V6 looks for a large leak by pulling a vacuum in the system. After switch-off it looks for a small leak. It does this based on the pressure change in the tank.

It also checks whether the purge valve closes properly and whether the vent is not blocked. If the vent is blocked, the car is also hard to refuel.

In numbers

Smallest leak the test finds (Saab 9-4X V6)
0.51 mm1
Large leak test
1 per cold start2
Tank pressure sensor signal
0.1 to 4.9 V1
Purge valve at rest
Closed1
Vent valve at rest
Open1
Engine warning light goes off
After 3 drives in a row without the fault4

Questions

Can a loose fuel cap really cause P0440?

Yes, it is one of the most common causes. The system sees an open tank as a leak.

Will my car fail the APK (the Dutch MOT) on P0440?

Usually not on the light alone. The vapour system has no effect on the exhaust gas test.

Is it dangerous?

No, not for the engine. Some petrol vapour escapes. That is mainly bad for the environment.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: Evaporative Emission Control System Description (factory manual)
  2. Saab WIS, 9-4X 2011 V6: DTC P0455 (factory manual)
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK handbook Regulations, article 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.