- How bad
- No rush
- Do it yourself
- Yes, you can do it yourself
- Usually
- Faulty purge valve
- Garage
- No repair needed
What you notice
- The engine warning light is on
- Sometimes a smell of petrol
- Sometimes hard starting after refuelling
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty purge valve | Common |
| Loose or corroded connector | Common |
| Damaged wiring | Sometimes |
| Blown fuse | Rare |
| Faulty engine computer | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Read all the codes. See whether there are more EVAP codes.
- 2Find the valve in the engine bay. It usually sits near the intake, with two hoses attached.
- 3Check that the connector is firmly in place and clean.
- 4Have the resistance of the valve measured.
- 5Replace the valve.
If you wait
Without a working purge valve, the charcoal canister is not emptied. If the valve stays open, vapour enters the engine at moments when the computer does not expect it. Saab names that as a cause of poor running.
First drive with the fault
The computer stores the fault.
Second drive in a row
The engine warning light comes on.
Weeks of driving on
Usually you notice nothing. Petrol vapour can escape.
At the APK
With this P code, the APK inspector carries out a standard exhaust gas test.
Background
How it works ›
What the purge valve does
Petrol vapour from the tank is captured in a canister of activated charcoal. The purge valve sits between that canister and the intake manifold. When the engine computer opens the valve, the engine draws fresh air through the canister. The vapour goes along with it and is burned.
The valve is closed at rest. The computer drives it with pulses, so it can control how much vapour passes through. Turbo engines have a non-return valve in the line. That keeps boost pressure out of the vapour system.
When the computer sets the code
P0443 is an electrical code. The valve receives ignition voltage, and the computer switches the earth. The Saab 9-4X V6 compares what it commands the valve to do with what it sees back on the control wire. If those do not match for at least 5 seconds, it sets P0443.
The test runs continuously with the ignition on, at 9 to 18 V.
In numbers
- Purge valve at rest
- Closed2
- Control
- Pulse width, the computer switches the earth1
- Limit for the code (Saab 9-4X V6)
- Command and circuit differ for at least 5 s1
- Test runs
- Ignition on, 9 to 18 V1
- Engine warning light on
- On the second drive in a row with the same fault3
- Engine warning light goes off
- After 3 drives in a row without the fault4
Questions
What does the charcoal canister purge valve do?
Your charcoal canister captures petrol vapour from the tank. This valve allows the engine to draw in that vapour. There it is burned.
Is P0443 dangerous?
No. The engine keeps running normally. The vapour capture system does not work properly.
Will my car fail the APK (the Dutch MOT) on P0443?
Not on the code alone. Because of the P code, the APK inspector measures the exhaust gases. You only fail the APK if the emissions are too high.
See also
Was this helpful?
· 5 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
- Saab WIS, 9-4X 2011 V6: DTC P0443 or P0449 (factory manual)
- Saab WIS, 9-4X 2011 V6: Evaporative Emission Control System Description (factory manual)
- Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
- UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
- RDW, APK handbook Regulations, article 42 and 45a to 45g (version from 1 January 2024) (in Dutch)