Which cars
- Peugeot 2008 with the 1.2 PureTech
- Peugeot 2008 BlueHDi diesel bought between August 2014 and August 2020
The problems
1.2 PureTech: wet beltThis week
- What you notice
- Oil light, message saying engine fault, have it repaired, brake assist fails, pedal goes heavy, engine dies.
- Cause
- The belt runs in oil and wears faster. Debris fouls the oil. It mostly concerns three-cylinders built between 2014 and 2017.
- Fix
- Have the belt checked around 6 years or 100,000 km and replaced if needed. Within that period, according to the ANWB (the Dutch motoring club), Stellantis pays all costs if the maintenance was done on time.
BlueHDi: AdBlue tank failsThis week
- What you notice
- AdBlue light, message counting down until the engine won’t start, engine light.
- Cause
- A software fault made the engine stop needlessly. The AdBlue tank then had to be replaced too early.
- Fix
- Have the tank replaced. Bought between August 2014 and August 2020? Then apply for compensation through the Stellantis platform.
1.2 PureTech: high oil consumptionWithin a month
- What you notice
- Oil level drops, blue smoke.
- Cause
- Besides the belt, a known complaint about the 1.2 PureTech.
- Fix
- Have the dealer measure the consumption. Under conditions you can reclaim costs from 2022 up to and including 2024 through the Stellantis platform.
Infotainment freezesNo rush
- What you notice
- Bluetooth music stutters, playlists won’t open.
- Cause
- Auto Express mentions problems with streaming music and opening playlists on the first 2008 (2013 to 2019). On the Peugeot 208, AutoReview reports that the infotainment freezes.
- Fix
- Turn the ignition off and on again. If the problem stays, have the dealer take a look.
Check this now (or before you buy)
- Ask for invoices of maintenance on schedule, with the right oil. Without those invoices the reimbursement lapses.
- Check when the timing belt was replaced or checked.
- Check your registration number on ovi.rdw.nl for the recalls for the belt and brake servo. The RDW published them for the 2008 in 2020 and 2022.
- Diesel? Read out the AdBlue faults before you buy.
If you wait
Belt wears in the oil
Particles of the belt get into the oil circuit.
Oil filter clogs
The vacuum pump gets too little lubrication.
Brake servo fails
The brake pedal needs much more force.
Belt pieces in the engine
The engine suffers major damage.
Background
How it works ›
Why the belt wears in the oil
On the 1.2 PureTech the timing belt runs through the engine oil. That makes the belt wear faster. Particles come loose and end up in the oil circuit.
The particles clog the oil filter. The vacuum pump then gets too little lubrication and the brake servo can fail. Worn-off belt pieces can also cause major engine damage.
What Stellantis did
In November 2020 and December 2022 the RDW published recalls for Peugeots with this engine, including the 2008. The dealer checks the belt and the brake servo. Then they put new software in the car. According to the ANWB it concerns cars from 2017 and 2018.
Outside the recall, according to the ANWB Stellantis pays all costs if the belt needs replacing within 6 years or 100,000 km and the maintenance was done on time. Older PureTech engines have an extended warranty up to 10 years or 180,000 km. The successor, the Turbo 100, has a timing chain.
AdBlue tank on the BlueHDi
On diesels from Peugeot, Citroën and Opel, a software fault made the engine stop needlessly. The AdBlue tank then had to be replaced early.
In December 2024 Stellantis promised the European regulators it would compensate owners. Cars bought between August 2014 and August 2020 may qualify.
In numbers
- Affected generation of three-cylinders
- Built between 2014 and 20171
- Original belt replacement schedule
- 175,000 km or 10 years1
- Dealer advice
- Check at 100,000 km or 6 years1
- 2022 recall, including the 2008
- 15,502 cars in the Netherlands4
- Extended warranty older PureTech
- 10 years or 180,000 km2
- Turbo 100 factory warranty
- 8 years or 160,000 km6
Questions
Is the Peugeot 2008 1.2 PureTech a good engine?
The older three-cylinders with a wet belt have had a lot of problems. The Turbo 100 has a timing chain. Peugeot launched it in March 2026 for the 208 and 2008.
What does engine fault, have it repaired mean on a Peugeot 2008?
The engine electronics see a fault. On a PureTech it can be low oil pressure from belt debris. Read the fault code straight away.
Does Peugeot pay for the timing belt on the 2008?
Often, yes. If the belt needs replacing within 6 years or 100,000 km, according to the ANWB Stellantis pays all costs. The condition is that the maintenance was done on time. That may also be at an independent garage.
See also
Was this helpful?
· 7 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
- ANWB: problems with PureTech engines (Dutch)
- AutoReview: buying advice Peugeot 208 (Dutch)
- ACM: Stellantis compensates for AdBlue problems (Dutch)
- RDW open data: recall MGP220494, timing belt Peugeot 2008 and other models (2022) (Dutch)
- RDW open data: recall MGP200507, timing belt Peugeot 2008 and other models (2020) (Dutch)
- TopGear NL: Peugeot introduces the Turbo 100 as successor to the PureTech (Dutch)
- Auto Express: Used Peugeot 2008 Mk1 (2013 to 2019), problems and recalls