Skip to contentBlack Friday · Reserve for €59 €69 after launch Reserve ›

Replacing the crankshaft sensor: what does it cost?

€89

One garage price.

If the crankshaft sensor fails, your car won’t start. Or it stalls while you drive, often when the engine is warm.

This weekDrive it as little as possible. The car can stall without warning. Get it done this week.

How bad
This week
Do it yourself
Possible, if you are handyOn some engines the sensor sits at the front and is easy to reach. On others it sits at the back, near the gearbox. First check that the plug is firmly in place. Also check that it isn’t wet or greasy.

Prices

Including 21% VAT, 19 November 2026. Where do they come from? ›

Garage, with labour

€89

One price.

Your garage charges something else? Tell us ›

Part only

€27

Middle of 2, €25 to €29.

Without fitting. A garage often replaces more parts with it.

What it does

The crankshaft sensor measures the position and speed of the crankshaft. That’s how the engine computer knows when to inject and ignite. Without that signal the engine won’t run.

How you notice

  • Engine turns over but doesn’t fire
  • Stalls when it’s warm
  • Rev counter drops out while you drive
  • Stuttering or jerking
  • Fault code P0335

If you wait

  1. Signal drops out now and then

    The engine can stall. The engine computer stores a fault code.

  2. Signal stays gone

    The engine starts with difficulty or won’t run.

  3. At the garage

    The garage reads the fault memory. Then it checks whether the sensor, plug and wiring are broken, corroded or dirty.

Background

+−BatteryEngine managementIgnition coilSpark plugCylinder headSparkPiston
How the ignition works
How it works ›

What the crankshaft sensor measures

The crankshaft sensor measures the speed and position of the crankshaft and sends that as an electrical signal to the engine computer. The computer uses it to work out when to inject and ignite.

The sensor usually sits near the flywheel ring gear. There are two types, an inductive sensor and a Hall sensor.

What makes it fail

HELLA lists an internal short circuit, a broken or shorted cable, damage to the toothed wheel and contamination by metal filings as causes.

A garage reads the fault memory first. Then it checks the plug and the wiring for breaks and corrosion. A Hall sensor must not be measured with an ohmmeter, because the test voltage can destroy it.

If you keep driving with it

The engine can stall. After that it starts with difficulty or not at all. That can also happen while you drive. So have the sensor and the wiring checked straight away.

In numbers

Measures
Speed and position of the crankshaft1
Location
Usually near the flywheel ring gear1
Types
Inductive or Hall1
Resistance of an inductive sensor
200 to 1,000 ohms, depending on the manufacturer’s spec1
Works with
The camshaft sensor, to find top dead centre of cylinder 12

Questions

What are the symptoms of a broken crankshaft sensor?

Your car won’t start. Or it stalls when it’s warm and starts again later. When you start it, the rev counter often does nothing.

Can a car run without a crankshaft sensor?

No. Without this signal the engine computer doesn’t know when to inject and ignite.

What’s the difference with the camshaft sensor?

The crankshaft sensor measures the crankshaft. The camshaft sensor measures the camshaft. The engine computer compares them to set the timing.

See also

Was this helpful?

· 2 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. HELLA Tech World, Crankshaft sensor
  2. HELLA Tech World, Camshaft sensor