Skip to content

P0012: Camshaft A over-retarded (bank 1)

Your intake camshaft is later than the computer asks for, on bank 1. Usually oil of the wrong viscosity or a sticking solenoid valve.

Within a monthYou can keep driving if the engine runs smoothly. Have it checked within a month.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
€89 to €1,000

What you notice

  • The engine warning light is on
  • Hard starting
  • Rough idle
  • Less power when pulling away

What usually causes it

CauseLikelihood
Too little, old or wrong engine oilCommon
Solenoid valve sticksCommon
Faulty actuator on the camshaftSometimes
Stretched timing chain or a belt that has jumped a tooth · €712Sometimes
Faulty camshaft position sensor · €89Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check the oil level and what the oil looks like.
  2. 2Change the oil, using the specified viscosity.
  3. 3Have the solenoid valve tested. Clean or replace it.
  4. 4Have the actuator checked.
  5. 5Does the code come back? Then have the timing measured.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

The computer advances the valve timing at moderate load, for lower fuel consumption and more low-end torque. If the camshaft stays too late, you lose that.

The actuator has a locking pin that only releases when there is oil pressure. So check the oil level before you look further.

  1. First drive with the fault

    The computer stores the fault.

  2. Second drive in a row

    The light comes on.

  3. Weeks of driving on

    Check your oil level. The actuator works on oil pressure.

  4. At the APK

    The APK inspector measures the exhaust gases. If they are too high, the car fails the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Timing chainGarage €712Part €100
Camshaft position sensorGarage €89Part €24

Background

CamshaftsCrankshaftTensionerWater pumpTiming beltTiming marks keep crankshaft and camshaft in step
How the crankshaft and camshaft run together
How it works ›

How variable valve timing works

The actuator sits on the end of the camshaft and is driven by the timing chain. A solenoid valve sends engine oil to one side or the other of the actuator. This turns the camshaft earlier or later relative to the crankshaft.

The engine computer measures the position with the camshaft position sensor and the crankshaft position sensor. With P0012, the intake camshaft on bank 1 is later than requested.

When the computer sets the code

In the factory manual for the Saab 9-4X V6, the computer looks at the difference between the requested and the measured position. If that is more than 5 degrees on the intake camshaft for longer than 2.5 seconds, a code follows. Saab reports it as P0011. Makes that report the direction separately use P0012 for too late.

The manual names an incorrectly fitted camshaft, solenoid valve, actuator or chain as a cause. So first check whether work was done on the engine recently.

In numbers

Solenoid valve control
Pulse width, the valve controls the oil flow to the actuator2
Deviation limit (Saab 9-4X V6)
More than 5 degrees, for longer than 2.5 s1
Actuator locking pin
Released by oil pressure, only then does adjustment start2
Engine warning light on
On the second drive in a row with the same fault3
Engine warning light goes off
After 3 drives in a row without the fault4

Questions

What is the difference between P0011 and P0012?

With P0011, the camshaft is too early. With P0012, it is too late. The causes are largely the same.

Is P0012 dangerous for the engine?

Not immediately. A stretched chain can jump over time. Then the engine gets damaged.

Will P0012 fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the usual way. Only if they are too high does the car fail the APK. The rules for each fuel type are in the APK guide. This fault can increase emissions.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0011, P0014, P0021 or P0024 (factory manual)
  2. Saab WIS, 9-4X 2011 V6: Camshaft Actuator System Description (factory manual)
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK handbook regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.