Skip to content

P0103: Mass airflow sensor A: signal too high

Your mass airflow sensor (MAF) gives a signal that is too high, higher than is possible. Usually it is a faulty sensor or a short circuit in the wires.

Within a monthYou can keep driving, gently. Have it repaired within a month.

How bad
Within a month
Do it yourself
Yes, you can do it yourself
Garage
Depends on the cause

What you notice

  • The engine warning light is on
  • Less power
  • Black smoke on diesels
  • Higher fuel consumption

What usually causes it

CauseLikelihood
Faulty mass airflow sensorCommon
Short circuit in the signal wireSometimes
Poor earth connectionSometimes
Interference from a loose spark plug lead or ignition coil nearbyRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check that the connector is firmly attached and dry.
  2. 2Check the wires for damage and chafing.
  3. 3Have the signal measured, at idle and when you accelerate.
  4. 4If the signal stays too high, fit a new sensor.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

With a signal that is too high, the computer sees more air than there is. According to the ANWB (the Dutch motoring club), the ratio of air to fuel is then wrong. The engine warning light can come on.

A mass airflow sensor lasts between 50,000 and 250,000 km, according to the ANWB.

  1. First drive with the fault

    The computer stores the fault.

  2. Second drive in a row

    The light comes on.

  3. Weeks of driving on

    The ratio of air to fuel is not ideal.

  4. At the APK

    The APK inspector measures the exhaust gases. If they are too high, your car fails the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Mass airflow sensorGarage nonePart €72

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

What the mass airflow sensor does

All the air the engine draws in flows past a heated film in the mass airflow sensor. The air cools the film. The electronics turn that cooling into a signal. The engine computer uses it to set the injection.

On a Saab, that signal is a frequency. In the 9-4X V6 it runs from about 2,000 Hz at idle to about 10,000 Hz at full load.

When the computer sets the code

In the Saab 9-4X V6, the computer sets P0103 when the signal stays above 14,500 Hz for more than 10 seconds. On the 2.8 turbo the limit is 15,152 Hz.

A resistance of 15 ohms or more in the supply wire can raise the reading by up to 60 g/s. If the signal wire touches the wire of the air temperature sensor, the signal becomes skewed or erratic.

In numbers

Normal signal (Saab 9-4X V6)
2,000 to 10,000 Hz1
P0103 limit (Saab 9-4X V6)
Above 14,500 Hz, for more than 10 s1
P0103 limit (Saab 9-4X 2.8 turbo)
Above 15,152 Hz2
Effect of resistance in the supply
15 ohms or more can read up to 60 g/s too high1
Mass airflow sensor replacement (ANWB)
€100 to €250 at a garage3
Engine warning light on
On the second drive in a row with the same fault4

Questions

Can you fix P0103 by cleaning the sensor?

Rarely. A signal that is too high is usually electrical, or the sensor is faulty.

What does it cost to fix P0103?

A new sensor at a garage costs €100 to €250, according to the ANWB (the Dutch motoring club).

Will P0103 make my car fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the usual way. You only fail if they are too high. The rules for each fuel type are in the APK guide. This fault can raise emissions.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0102 or P0103 (factory manual)
  2. Saab WIS, 9-4X 2011 2.8 turbo: DTC P0100 to P0103 (factory manual)
  3. ANWB, What does a mass airflow sensor do? (in Dutch)
  4. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  5. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.