Skip to content

P0174: Mixture too lean (bank 2)

Your engine is getting too much air for the petrol, on bank 2. Usually it is a leaking hose or a dirty mass airflow sensor (MAF).

Within a monthYou can keep driving. Have it checked within a month, before the engine starts to misfire.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
€112 to €350

What you notice

  • Rough or hunting idle
  • It hesitates when pulling away
  • Less power
  • Sometimes a misfire, especially when the engine is cold
  • Hissing under the bonnet

What usually causes it

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1If P0171 is there too, both banks are lean. Usually that is unmetered air, the mass airflow sensor or the fuel pressure.
  2. 2Start the engine. If you hear hissing anywhere, check all hoses for cracks, including those of the crankcase ventilation.
  3. 3Look at the fuel trim in the app. If it is high at idle and lower at 2,500 rpm, it is a leak.
  4. 4Clean the mass airflow sensor with MAF cleaner.
  5. 5Have the garage do a smoke test. That finds leaks in the intake.
  6. 6Have the fuel pressure measured. If it is too low, it is the filter or the pump.
  7. 7Have the exhaust before the lambda sensor of bank 2 checked for leaks.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

After two drives in a row with the fault, the engine warning light comes on. The manual lists a mixture that is too lean as one of the causes of a worse catalytic converter.

  1. First drive with the fault

    The computer stores the fault. The light stays off for now.

  2. Second drive in a row

    The engine warning light comes on.

  3. Weeks of driving on

    You use more fuel. The catalytic converter can suffer.

  4. At the APK (the Dutch MOT)

    The APK inspector measures the exhaust gases. If they are too high, you fail the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Mass airflow sensorGarage nonePart €72
Fuel pumpGarage €263Part none
InjectorsGarage nonePart €117
Lambda sensorGarage €116Part €79
Throttle bodyGarage nonePart €133

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

What fuel trim is

The engine computer adjusts the injection based on the signal from the lambda sensor. That correction is called fuel trim. The short-term trim reacts quickly, the long-term trim shifts slowly along with it. A positive trim means the computer adds fuel because the mixture is too lean.

With a warm engine, the trim is normally between -10 and +10 %. In the factory manual of the Saab 9-4X V6, the computer sets P0171 or P0174 if the long-term trim stays outside the limit for about 3 minutes. P0174 is about bank 2.

Where the extra air comes from

Any air that the mass airflow sensor does not measure makes the mixture lean. That can be a leaking vacuum hose, a loose oil filler cap or a dipstick that is not seated properly in its tube. A mass airflow sensor can also measure wrongly without its own fault code.

The manual also says the lambda sensor does not cause this code as long as there is no sensor code with it. A new sensor will then not fix P0171 or P0174.

If P0171 is there too, both banks are lean. Then look for something both sides share, such as the mass airflow sensor or the fuel pressure.

In numbers

Normal fuel trim
Between -10 and +10 %, ideal 0 %1
Code set after
About 3 minutes of abnormal long-term trim1
Front lambda sensor signal
About 40 to 900 mV, switching with the mixture1
Lean or rich according to Bosch
Below 0.4 V lean, above 0.5 V rich3
Engine warning light on
On the second drive in a row with the same fault2
Replacing the MAF (ANWB, the Dutch motoring club)
€100 to €250 at the garage4
Engine warning light goes off
After 3 drives in a row without the fault6

Questions

What is bank 2?

The row of cylinders without cylinder 1. Only V engines and boxer engines have a bank 2.

Can I keep driving with P0174?

Yes, gently. Have it checked within a month. A lean mixture burns hotter. Over time the engine starts to misfire and the valves can be damaged.

Will I pass the APK (the Dutch MOT) with P0174?

Not on the code alone. With a P-code in the memory, the APK inspector measures the exhaust gases. You only fail the APK if that measurement is too high. The rules for each fuel type are in the APK guide.

Why does a vacuum leak give P0174?

Through the leak, air gets in that the mass airflow sensor does not measure. The computer then injects too little petrol for that air.

See also

Show 5 more ›

Was this helpful?

· 7 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0171, P0172, P0174 or P0175 (factory manual)
  2. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  3. Bosch, Checking the signal of lambda sensors (workshop sheet) (in Dutch)
  4. ANWB, What does a mass airflow sensor do? (in Dutch)
  5. Saab WIS, 9-4X 2011 V6: DTC P0420 or P0430 (factory manual)
  6. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  7. RDW, APK handbook Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.