- How bad
- This week
- Do it yourself
- No, that is a garage job
- Garage
- €175 to €350
What you notice
- The engine warning light is on
- Car in limp mode
- Hesitation when pulling away
- Hard starting or stalling
What usually causes it
| Cause | Likelihood |
|---|---|
| Clogged fuel filter | Common |
| Weak fuel pump in the tank · €263 | Common |
| Tank almost empty, or air in the system | Sometimes |
| Worn high-pressure pump · €263 | Sometimes |
| Faulty pressure control valve or rail pressure sensor | Sometimes |
| Injector with too much leak-back | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Fill the tank up. See whether the code comes back.
- 2Has the fuel filter been in longer than specified? Replace it.
- 3Have the pressure of the tank pump measured.
- 4When pulling away, watch the rail pressure in the app. Requested and actual should move together.
- 5Have the garage test the injectors for leak-back and check the high-pressure pump.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
With too little pressure, the injectors get too little fuel. For a bad injector, the ANWB lists hard starting, loss of power, smoke and higher fuel consumption.
First time with too little pressure
The computer stores the fault.
Driving on
Hard starting, hesitation or smoke can follow.
Pressure drops further
The engine can stall. Do not drive any further then.
What it costs
It depends on the cause. Where do the prices come from? ›
Background
How it works ›
How rail pressure builds up
With direct injection, a high-pressure pump pumps fuel into a shared line, the rail. The injectors take their fuel from that rail. A pressure sensor reports the pressure to the engine computer, which adjusts the pump. With P0087, the measured pressure is lower than the requested pressure.
The pressures vary widely. A petrol engine with injection into the intake manifold works at about 3 bar. A petrol engine with direct injection uses about 200 bar. The Bosch common rail system for diesels reaches up to 2,700 bar.
Where the pressure drops
The European OBD rules require diesel systems to monitor the injection for interruptions and complete failure.
According to the ANWB (the Dutch motoring club), an injector lasts 150,000 to 250,000 km on average. Replacement costs €150 to €600 each, according to the ANWB. On a diesel it costs more than on a petrol engine.
In numbers
Questions
Can a fuel filter cause P0087?
Yes. On diesels it is the most common cause.
What does a new high-pressure pump cost?
Garages charge €175 to €1,470 for a fuel pump. Have the cheaper causes ruled out first.
Will P0087 fail the APK (the Dutch MOT)?
For most cars, not on the light alone. On a diesel, the APK inspector tests the smoke. An engine that runs poorly can fail on that.
See also
Was this helpful?
· 3 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.