Skip to content

P0202: Injector cylinder 2 circuit fault

There is an electrical fault on the injector of cylinder 2. That cylinder then misfires. Usually it is a loose connector or a faulty injector.

This weekA short, gentle drive to the garage is fine. Have it fixed this week. Stop if the engine warning light flashes.

How bad
This week
Do it yourself
Possible, if you are handy
Garage
€329 to €600

What you notice

  • Engine misfires and shakes
  • The engine warning light is on, often together with P0302
  • Less power
  • Long cranking
  • Smell of petrol or diesel

What usually causes it

CauseLikelihood
Loose, dirty or corroded connector on the injector of cylinder 2Common
Faulty coil in the injector of cylinder 2Common
Chafed or broken wire to the injectorSometimes
Faulty fuse or relay for the injector supplyRare
Faulty injector driver in the engine computer (ECU)Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Check that the connector on the injector of cylinder 2 clicks firmly in place. It should be free of oil and corrosion.
  2. 2Follow the cable to the injector. Look for chafing or melted insulation.
  3. 3Measure the resistance of the injector of cylinder 2. Compare it with the others. If it is much higher or infinite, there is a break in the circuit.
  4. 4Have the supply and the cable to the engine computer tested.
  5. 5Have the injector of cylinder 2 replaced. On diesels and direct injection engines, the new one often has to be programmed.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

The computer switches off the faulty injector. Cylinder 2 then gets no fuel.

According to the ANWB (the Dutch motoring club), an injector lasts 150,000 to 250,000 km on average.

  1. Code appears

    The computer switches off the injector of cylinder 2.

  2. While driving

    The engine misfires. It pulls less.

  3. Saab 9-5 diesel

    The computer can also switch off cylinder 3.

  4. At the APK (the Dutch MOT)

    With a P-code, the APK inspector measures the exhaust gases. If the car is registered with a diesel particulate filter (DPF), the inspector always measures with a particle counter.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
InjectorsGarage nonePart €117
Catalytic converterGarage €339Part €240

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

How the computer controls an injector

The injector gets voltage from the engine computer. It opens as soon as the computer switches the control wire to earth. Both wires are monitored. P0202 is about the injector of cylinder 2.

When the computer sets the code

On the Saab 9-4X V6, the computer sets the code if the injector circuit is open for more than 2 seconds. There, a short to earth gives P0264 and a short to positive gives P0265.

The Saab 9-5 diesel checks on every camshaft revolution whether the command and the circuit match. The injectors there are in two groups. Cylinder 2 shares a group with cylinder 3. With a fault, the computer can switch off the whole group.

In numbers

Threshold (Saab 9-4X V6)
Circuit open for more than 2 s1
Computer response
Injector of cylinder 2 switched off1
Injector group (Saab 9-5 diesel)
Cylinders 2 and 3 together2
Engine warning light on (Saab 9-5 diesel)
Straight away, at the first failed test2
Injector lifespan
150,000 to 250,000 km on average3
Replacing an injector (ANWB)
€150 to €600 each, fitted3

Questions

Can I keep driving with P0202?

Only a short, gentle drive. If the engine warning light flashes, stop. Unburnt fuel can damage your catalytic converter.

What does a new injector cost?

€150 to €600 each, fitted, according to the ANWB (the Dutch motoring club). On a diesel it costs more than on a petrol engine.

How do I know which cylinder is number 2?

That differs per make and engine. Look it up in the workshop data for your engine code, or ask the garage.

Will I pass the APK (the Dutch MOT) with P0202?

Not on the code alone. With a P-code in the memory, the APK inspector measures the exhaust gases. You only fail the APK if that measurement is too high. The rules for each fuel type are in the APK guide. A cylinder without fuel can make that measurement fail.

See also

Was this helpful?

· 6 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0201 to P0206 and P0261 to P0277 (factory manual)
  2. Saab WIS, 9-5 2011 diesel: DTC P0201 to P0204 (factory manual)
  3. ANWB, The injector explained and replacement costs (in Dutch)
  4. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  5. RDW, APK handbook Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
  6. RDW, APK Keurmeester No. 110 (September 2025): when is a soot measurement required? (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.