- How bad
- This week
- Do it yourself
- No, that is a garage job
- Usually
- Low battery voltage or a bad earth
- Garage
- usually €118
What you notice
- Many warning lights on the dashboard at once
- Car will not start or stalls
- Many U codes at once
- Automatic gearbox in limp mode
What usually causes it
| Cause | Likelihood |
|---|---|
| Low battery voltage or a bad earth · €118 | Common |
| Corroded or loose connector in the network | Common |
| Damaged wiring, for example from an accident or rodents | Sometimes |
| One faulty module disrupting the network | Sometimes |
| Aftermarket electronics fitted on the CAN bus | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Have the battery tested. Check the earth cables.
- 2Has a radio, tow bar or alarm been fitted recently? It may be connected to the bus.
- 3Read out all the modules. The ones that do not respond point to where the problem is.
- 4Have the garage measure the resistance of the bus. On most cars it should be around 60 ohms.
- 5Have the garage disconnect the modules one by one. That way they find the module causing the interference.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What does an original part cost, and what does a pattern part cost?
- What will it cost if you find more? Call me before you go ahead.
If you wait
While the fault is active, a code reader often cannot reach the modules on the bus. Diagnosis then relies on the symptoms and on measuring the wiring.
The code stops being an active fault as soon as the problem is gone. It clears from the memory after a set number of ignition cycles without the fault.
Code active
A module no longer takes part on the bus. Functions drop out.
Reading the codes fails
The garage measures the bus wiring.
At the APK
The OBD check only looks at codes starting with a P.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Battery | Garage €118 | Part none |
Background

How it works ›
What the high-speed CAN bus is
The most important computers in the car exchange their data over the high-speed CAN bus. Each module counts transmit errors and receive errors separately. An error counts up, a good message counts down.
When the computer sets the code
On a Saab, if the transmit error counter goes above 255, the module takes itself off the bus. It then sets U0001. It stops transmitting and works with fixed values instead of received data.
According to the manual, a fault that comes and goes usually points to a short circuit in one of the bus wires.
In numbers
Questions
What is the CAN bus?
The network the computers in your car use to talk to each other. Over two wires, the engine, gearbox, ABS and dashboard exchange information.
Can mice or martens cause this?
Yes. Chewed-through cables in the engine bay are a known cause of network faults.
Why do I get so many codes at once?
If the network is not working properly, all the modules lose contact with each other. Each module then stores its own communication code.
See also
Was this helpful?
· 2 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.