Skip to content

U0100: Lost communication with the engine computer

Another module in your car can no longer make contact with the engine computer (ECU). Usually it is a flat battery, a bad earth or a loose connector.

This weekDrive as little as possible. Have it checked this week. The engine can cut out or stop starting.

How bad
This week
Do it yourself
No, that is a garage job
Usually
Low battery voltage, for example after a jump start or a flat battery
Garage
usually €118

What you notice

  • Car will not start or stalls
  • Many warning lights on the dashboard at once
  • Rev counter or temperature gauge drops out
  • Automatic gearbox in limp mode

What usually causes it

CauseLikelihood
Low battery voltage, for example after a jump start or a flat battery · €118Common
Loose or corroded earth cableCommon
Engine computer connector loose or corrodedSometimes
Damaged CAN bus wiringSometimes
Blown engine computer fuseSometimes
Faulty engine computerRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Read the battery voltage in the app. Below about 12 volts with the engine off, the battery is weak.
  2. 2Check the battery terminals and the earth cables to the engine and body.
  3. 3Clear the codes and see if U0100 comes back. After a flat battery or a jump start, an old message often stays stored.
  4. 4Check the engine computer fuses.
  5. 5Have the garage measure the CAN bus and check the engine computer connector.
  6. 6Is everything else in order? Then have the engine computer tested or reconditioned.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What does an original part cost, and what does a pattern part cost?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

If the code is only in the memory and not active, often nothing is broken. Saab mentions low battery voltage, a module that has been disconnected, and modules that do not start up at the same time after the battery is reconnected.

If the code is active, the engine can cut out or fail to start.

  1. Code active

    On a Saab, the automatic gearbox goes into fixed gears. The engine warning light is on.

  2. Engine cuts out or will not start

    Have the power supply and earth of the engine computer measured.

  3. At the APK

    The OBD check only looks at codes starting with a P.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
BatteryGarage €118Part none

Background

Vroom Doctor in the OBD port under the steering wheel, above the pedals
How it works ›

How modules keep an eye on each other

The computers in the car exchange data over a data line. With the ignition on, each module regularly sends a message that it is working. If a module drops out, for example because it has lost its power supply or earth, that message stops.

The modules expecting the message then set a code. With U0100, the message from the engine computer is missing.

What the code does and does not tell you

The module that stores the code is not the module with the problem. According to the Saab factory manual, never replace a module because it reports a U code.

Look at the engine computer: power supply, earth, fuse and connectors. Oxidised pins in a connector cause a fault that comes and goes.

In numbers

Battery voltage for the test (Saab 9-4X)
9 to 16 V1
Code clears from memory (Saab 9-4X)
After 50 ignition cycles without the fault1
Engine warning light goes off (Saab 9-4X)
After 4 ignition cycles without the fault1
Effect on the automatic gearbox (Saab 9-4X)
Fixed gears1
Battery lifespan
3 years with normal use2
APK check via OBD
Only looks at codes starting with a P3

Questions

What does U0100 mean if the car drives normally?

Then it is often an old message, from a moment of low voltage. For example, during starting. Clear the code and see if it comes back.

Can a flat battery cause U0100?

Yes, that is one of the most common causes. At low voltage, the engine computer can drop out briefly.

Is my engine computer broken?

Usually not. The battery, earth, fuses and connectors are far more often the cause.

Will U0100 fail the APK (the Dutch MOT)?

The code itself is not on the list of fail items. If the ABS or airbag light is also on, it does fail on a car first used after 31 December 2017. On an older car, you get repair advice.

See also

Was this helpful?

· 4 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011: DTC U0100 to U02FF (factory manual)
  2. ANWB, How does a battery work and when should you replace your battery? (in Dutch)
  3. RDW, APK-handboek Regelgeving (APK regulations manual), articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
  4. RDW, APK-handboek Regelgeving (APK regulations manual), articles 5.2.31 and 5.2.47 and repair advice items (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.