Skip to content

P0600: Serial communication link malfunction

Your engine computer sees a communication fault, internally or with another module. Usually it is the battery, the earth or a connector.

This weekDrive as little as possible. Have it checked this week. The car can go into limp mode.

How bad
This week
Do it yourself
No, that is a garage job
Usually
Low battery voltage or poor earth
Garage
usually €118

What you notice

  • The engine warning light is on
  • Limp mode or less power
  • Sometimes gear change problems or other warning lights

What usually causes it

CauseLikelihood
Low battery voltage or poor earth · €118Common
Corroded engine computer connectorSometimes
Damaged wiring in the networkSometimes
Outdated software in the engine computerSometimes
Faulty engine computerRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Have the battery tested. Check that the terminals are tight.
  2. 2Check the engine and body earth cables.
  3. 3Read out all modules. Other communication codes point to the real cause.
  4. 4Ask the garage about a software update.
  5. 5Have the engine computer tested or reconditioned.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What does an original part cost, and what does a pattern part cost?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

If communication drops out, parts of the car do not work. On Saab, the automatic gearbox then goes to fixed gears.

Reprogramming an engine computer needs special equipment and the right software for the car.

  1. Code appears

    Check the battery, terminals and earth first.

  2. Code returns

    Have the supply, earth and data line of the engine computer measured.

  3. At the APK

    With a P-code, the APK (the Dutch MOT) inspector measures the exhaust gases in the standard way.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
BatteryGarage €118Part none

Background

Vroom Doctor in the OBD port under the steering wheel, above the pedals
How it works ›

How modules talk to each other

The computers in the car exchange data over a serial data line. With the ignition on, each module regularly sends a message that it is working. If that message stops arriving, the other modules notice.

The engine computer sets P0600 when it sees a fault in that serial link.

Where to start

The Saab factory manual starts with the power supply. A low voltage or a brief interruption of the positive or earth can set a code for the engine computer itself. Check that the battery is fully charged. Also check that the battery terminals are clean and tight.

Then check the earth cables and supply wires of the engine computer for open circuits, short circuits and resistance.

In numbers

Battery voltage for communication tests (Saab 9-4X)
9 to 16 V1
First check
Battery charged, terminals clean and tight2
Second check
Engine computer earth and supply2
Engine warning light goes off
After 3 drives in a row without the fault4

Questions

Is my engine computer broken with P0600?

Not necessarily. Often it is the voltage or a connector. Only when those are fine does the computer come into the picture.

What does reconditioning an engine computer cost?

Reconditioning is often cheaper than a new computer that still has to be programmed.

Will P0600 fail the APK?

Usually not on the light alone. In limp mode, the emissions can be off for the APK (the Dutch MOT) test.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011: DTC U0100 to U02FF (factory manual)
  2. Saab WIS, 9-4X 2011 V6: DTC P0601 to P0606, P062B, P062F, P0630, P16F3 or P2610 (factory manual)
  3. Saab WIS, 9-4X 2011 V6: Engine Control Module Description (factory manual)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.