Skip to content

P0001: Fuel volume regulator: control circuit open

The circuit to the control valve on your high-pressure pump is broken. Usually a loose connector or a damaged cable.

This weekDrive as little as possible, the engine can hesitate or stall. Have it checked this week.

How bad
This week
Do it yourself
No, that is a garage job
Garage
€175 to €350

What you notice

  • The engine warning light is on
  • The car goes into limp mode
  • Less power, or hesitates when you accelerate
  • Hard starting or stalling

What usually causes it

CauseLikelihood
Loose or corroded connector on the control valveCommon
Damaged cable to the engine computerCommon
Faulty control valveSometimes
Faulty high-pressure pump with built-in regulator · €263Rare
Faulty engine computerRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Read all codes. Look for P0087 or P0088 alongside it.
  2. 2Check the connector on the control valve at the high-pressure pump. Is it secure and clean?
  3. 3Follow the cable to the engine computer. Look for chafed spots.
  4. 4Have the resistance of the valve measured and compared with the factory value.
  5. 5If it differs, fit a new control valve. On some engines it is attached to the pump.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

On the Saab 9-5 diesel these are type A codes. The engine warning light comes on straight away.

Without a working valve, the computer cannot control the rail pressure. In this Saab, the high-pressure pump delivers up to 1,600 bar.

  1. First drive with the fault

    The engine warning light comes on at the first failed test.

  2. While driving

    The rail pressure is no longer controlled.

  3. At the APK

    With a P code, the APK inspector measures the exhaust gases. If the car’s registration lists a diesel particulate filter, they always measure with a particle counter.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Fuel pumpGarage €263Part none

Background

Air filterMass airflow sensorThrottleInjectorIntake manifoldTo exhaustPistonFuel tankFuel pump
How the air and fuel mixture is made
How it works ›

What the volume regulator does

On a common rail diesel, the high-pressure pump has a control valve on the intake side. When the engine needs little fuel, the valve restricts the supply. The pump cylinders then do not fill completely. This way the pump uses less power.

The engine computer controls the valve with a pulsed signal. It measures the result as pressure in the rail. It then adjusts the signal until the pressure is right.

When the computer sets the code

The Saab 9-5 diesel has its own code for the control valve on the pump, P0251. It appears when the control circuit is open for longer than 1 second. The test runs with the ignition on, below 16 V.

A short to earth is P0253 there, a short to positive P0254.

In numbers

Control valve signal
Pulse width from the engine computer2
Limit (Saab 9-5 diesel)
Circuit open for longer than 1 s1
Test runs
Ignition on, voltage below 16 V1
Engine warning light on (Saab 9-5 diesel)
Straight away, at the first failed test1
Maximum pump pressure (Saab 9-5 diesel)
Up to 1,600 bar2

Questions

What is a fuel volume regulator?

An electric valve on or near the high-pressure pump. It decides how much fuel goes to the rail. That is how it controls the pressure.

What is the difference between P0001 and P0002?

With P0001, the current to the valve is interrupted. With P0002, the current works, but the valve does not do what the computer asks.

Will P0001 fail the APK (the Dutch MOT)?

Not on the code alone. Because of the P code, the APK inspector does a standard exhaust gas test. If emissions are above the limit, your car fails the APK.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-5 2011 diesel: DTC P0251 to P0254 (factory manual)
  2. Saab WIS, 9-5 2011 diesel: Fuel System Description (factory manual)
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. RDW, APK handbook regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
  5. RDW, APK Keurmeester No. 110 (September 2025): when is a soot measurement mandatory? (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.