- How bad
- Within a month
- Do it yourself
- Possible, if you are handy
- Garage
- Depends on the cause
What you notice
- The engine warning light is on
- The radiator fan keeps running
- The temperature gauge behaves oddly
- Hard starting
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty coolant sensor | Common |
| Loose or corroded connector | Common |
| Damaged wiring | Sometimes |
| Faulty engine computer (ECU) | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Check that the connector on the sensor is firmly in place.
- 2Check the connector and wires for corrosion and breaks.
- 3Compare the coolant temperature in the app with your temperature gauge.
- 4Replace the sensor. Then top up the coolant and bleed the system.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
With a code for this circuit, the Saab can switch the radiator fans to their highest speed. They only switch off again once the code has been cleared.
HELLA lists a higher idle speed, higher fuel consumption and poor starting as complaints.
First drive with the fault
The computer stores the fault.
Second drive in a row
The light comes on.
Radiator fans keep running
That is the computer’s response to the code.
At the APK
The APK inspector measures the exhaust gases. If they are too high, you fail the APK.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Thermostat | Garage none | Part €20 |
Background
How it works ›
How the temperature sensor works
The sensor is a resistor in the coolant. The engine computer puts 5 V on the signal wire. A cold engine gives a high resistance and a high voltage. A warm engine gives a low one.
HELLA gives a guide value of 2.0 to 6 kOhm at 25 °C and about 300 ohm at 80 °C.
When the computer sets the code
P0115 is the general code for the circuit. The Saab 9-4X V6 splits the fault out. If the computer reads more than 140 °C for longer than 1 second, it is P0117. If it reads less than -39 °C, it is P0118.
After a night parked, the coolant sensor and the intake air sensor should read within 3 °C of each other. That is a quick check with a code reader.
In numbers
- Sensor supply
- 5 V from the engine computer1
- Resistance at 25 °C
- 2.0 to 6 kOhm2
- Resistance at 80 °C
- About 300 ohm2
- Too hot limit (Saab 9-4X V6)
- Above 140 °C, for longer than 1 s1
- Too cold limit (Saab 9-4X V6)
- Below -39 °C, for longer than 1 s1
- Engine warning light on
- On the second drive in a row with the same fault3
Questions
Why does my radiator fan run all the time with P0115?
Without a reliable temperature, the computer turns the fan on to be safe. That way the engine does not overheat.
What does a new temperature sensor cost?
That depends on the engine. Coolant is added on top. Garages charge €75 to €103 per hour.
Will P0115 make you fail the APK (the Dutch MOT)?
Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the normal way. You only fail the APK if they are too high. The rules per fuel type are in the APK guide. This fault can raise emissions.
See also
Was this helpful?
· 4 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.