- How bad
- Within a month
- Do it yourself
- Possible, if you are handy
- Garage
- Depends on the cause
What you notice
- The engine warning light is on
- The engine warms up slowly
- The heater stays lukewarm
- The temperature gauge jumps
What usually causes it
| Cause | Likelihood |
|---|---|
| Thermostat stuck open | Common |
| Sensor reads off | Common |
| Too little coolant, or air in the system | Sometimes |
| Poor connector | Sometimes |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Check the coolant level with the engine cold.
- 2Drive for 15 minutes and watch the coolant temperature in the app.
- 3If it stays below about 80 °C, fit a new thermostat.
- 4If the value jumps, or is wrong with a cold engine, fit a new sensor.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
HELLA links an engine that does not reach its minimum temperature to the thermostat. If the temperature gauge stays low, have the thermostat checked too.
According to the ANWB (the Dutch motoring club), a thermostat at the garage costs 25 to 180 euros, with just over an hour to 3 hours of work.
First cold start with the fault
The computer stores the fault.
Second drive in a row
The light comes on.
Weeks of driving on
An engine that stays too cold uses more fuel.
At the APK
The APK inspector measures the exhaust gases. If they are too high, you fail the APK.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Thermostat | Garage none | Part €20 |
Background
How it works ›
What the computer compares
The engine computer knows the coolant temperature and the intake air temperature. After a long time parked, the engine and the air are equally warm. The two sensors should then read almost the same.
When the computer sets the code
The Saab 9-4X V6 runs the test after at least 330 minutes parked, if the drive before lasted longer than 10 minutes. If the difference between the two sensors at ignition on differs by more than 14 °C from what the computer recorded earlier, it sets P0116.
The manual mentions resistance in the wiring of either sensor. Coolant leaking into the sensor connector also gives this code.
In numbers
- Time parked before the test (Saab 9-4X V6)
- At least 330 minutes1
- Limit for the code
- More than 14 °C deviation between coolant and intake air1
- After a night parked
- Both sensors within 3 °C of each other1
- Sensor resistance at 25 °C
- 2.0 to 6 kOhm2
- Thermostat at the garage (ANWB)
- €25 to €180, just over 1 to 3 hours of work3
- Engine warning light on
- On the second drive in a row with the same fault4
Questions
What is the difference between P0116 and P0128?
P0116 doubts the sensor. With P0128 the engine warms up too slowly, usually because of the thermostat.
Can too little coolant cause P0116?
Yes. If the sensor sits in air instead of liquid, it measures wrongly.
Will P0116 make you fail the APK (the Dutch MOT)?
Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the normal way. You only fail the APK if they are too high. The rules per fuel type are in the APK guide. This fault can raise emissions.
See also
Was this helpful?
· 5 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.