- How bad
- Within a month
- Do it yourself
- Possible, if you are handy
- Garage
- Depends on the cause
What you notice
- The engine warning light is on
- The radiator fan keeps running
- The temperature gauge reads high
- Hard starting when the engine is cold
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty coolant sensor | Common |
| Short circuit to earth in the signal wire | Sometimes |
| The engine really is too hot | Sometimes |
| Faulty engine computer (ECU) | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Look at your temperature gauge. Carefully feel whether the upper radiator hose is hot.
- 2Check the coolant level with the engine cold.
- 3Unplug the sensor connector. If the code changes to P0118, the sensor is probably faulty.
- 4Replace the sensor and bleed the cooling system.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
If the computer reads an engine that is too hot, the Saab can switch the radiator fans to their highest speed. They keep running until the code has been cleared.
According to HELLA, you may also notice a higher idle speed, higher fuel consumption and poor starting.
First drive with the fault
The computer stores the fault.
Second drive in a row
The light comes on.
Radiator fans keep running
That is the computer’s response to the code.
At the APK
The APK inspector measures the exhaust gases. If they are too high, you fail the APK.
Background
How it works ›
How the temperature sensor works
In the coolant sits a sensor with a resistance that drops as it gets warmer. The engine computer puts 5 V on it. A cold engine gives a high voltage, a warm engine a low one.
HELLA gives a guide value of 2.0 to 6 kOhm at 25 °C and about 300 ohm at 80 °C.
When the computer sets P0117
The computer reads a low voltage as a hot engine. The Saab 9-4X V6 sets P0117 if it reads more than 140 °C for longer than 1 second, or for 10 seconds added together.
HELLA names a short circuit to earth in the wiring or in the sensor itself as the cause.
In numbers
- Sensor supply
- 5 V from the engine computer1
- P0117 limit (Saab 9-4X V6)
- Above 140 °C, for longer than 1 s1
- Resistance at 80 °C
- About 300 ohm2
- Signal wire insulation to earth
- More than 30 MOhm2
- After a night parked
- Within 3 °C of the intake air sensor1
- Engine warning light on
- On the second drive in a row with the same fault3
Questions
What is the difference between P0117 and P0118?
With P0117 the computer reads an engine that is too hot, with P0118 one that is too cold. Both usually point to the sensor or the wires.
Can I keep driving with P0117?
Briefly, if the engine really is at its normal temperature. Check that first.
Will P0117 make you fail the APK (the Dutch MOT)?
Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the normal way. You only fail the APK if they are too high. The rules per fuel type are in the APK guide. This fault can raise emissions.
See also
Was this helpful?
· 4 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.