Skip to content

P0343: Camshaft position sensor A: signal too high (bank 1)

The signal from camshaft position sensor A on bank 1 is higher than it can be. Usually it is a broken wire or a loose connector.

Within a monthYou can keep driving gently. Have it checked within a month.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
€89

What you notice

  • The engine warning light is on
  • The engine takes longer to start
  • Hesitation or less power

What usually causes it

CauseLikelihood
Broken earth or signal wireCommon
Loose or corroded connectorCommon
Faulty camshaft position sensor · €89Common
Short circuit to the supply voltageSometimes
Faulty engine computer (ECU)Rare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Read the codes and clear them. See whether the code comes back straight away.
  2. 2Check that the connector on the camshaft position sensor is secure, and whether there is oil in it.
  3. 3Have the earth wire and the signal wire measured.
  4. 4If the wiring is fine, fit a new camshaft position sensor.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

If the signal drops out now and then, the engine can stall. According to HELLA, you can also get starting problems, a lit engine warning light and limp mode.

  1. Code appears

    The engine may take longer to start.

  2. Signal drops out while driving

    The engine may stall.

  3. At the APK

    A stored P code means a standard exhaust gas test.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Camshaft position sensorGarage €89Part €24

Background

CamshaftsCrankshaftTensionerWater pumpTiming beltTiming marks keep crankshaft and camshaft in step
How the crankshaft and camshaft run together
How it works ›

How the camshaft position sensor works

The sensor is a Hall-effect switch. It reads a wheel with 4 teeth on the camshaft. It gets 5 V and earth from the engine computer. In return it gives a square wave: alternately high and low.

Sensor A on bank 1 is the sensor for the intake camshaft at cylinder 1. The computer uses it to time injection and ignition with the engine.

When the computer sets the code

The Saab 9-4X 2.8 turbo sets the code when the signal voltage stays high. The computer then sees no pulses for longer than 1 second, or for 10 seconds added together.

The test runs after 10 crankshaft revolutions, below 2,520 rpm. The manual also lists damage, play, too large an air gap and dirt between the sensor and the wheel.

In numbers

Sensor wheel (Saab 9-4X)
4 teeth1
Sensor supply
5 V from the engine computer1
P0343 threshold (Saab 9-4X 2.8 turbo)
Signal stays high, no pulses for longer than 1 s1
Test runs
After 10 crankshaft revolutions, below 2,520 rpm1
Supply according to HELLA
About 5 V, follow the manufacturer’s specification2

Questions

Can oil in the connector cause P0343?

Yes. If the sensor leaks oil past its seal, the oil sometimes creeps into the connector. That disturbs the contact.

What does P0343 cost at a garage?

A garage charges about €89 for a new camshaft position sensor.

Will my car fail the APK (the Dutch MOT) with P0343?

Not because of the fault code. The APK inspector does measure the exhaust gases. If the emissions are above the limit, your car fails the APK.

See also

Was this helpful?

· 3 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 2.8 turbo: DTC P0341 to P0393 (factory manual)
  2. HELLA Tech World, Camshaft sensor: function, fault symptoms and troubleshooting
  3. RDW, APK handbook: Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.