Skip to content

P0500: Vehicle speed sensor A fault

Your engine computer is not getting a proper speed signal. Usually an ABS sensor, dirt on the sensor or a damaged cable.

Within a monthYou can keep driving calmly. Have it fixed within a month.

How bad
Within a month
Do it yourself
Possible, if you are handy
Garage
Depends on the cause

What you notice

  • Speedometer drops out or jumps
  • Automatic gearbox shifts oddly or at the wrong moment
  • Cruise control does not work
  • Sometimes the ABS warning light or the engine warning light is on

What usually causes it

CauseLikelihood
ABS sensor or speed sensor faultyCommon
Dirt or metal particles on the sensorSometimes
Damaged cable to the sensorSometimes
Fault in the ABS moduleRare
Instrument cluster does not pass the signal onRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1Also read the codes from the ABS module. An ABS code often points straight to the wheel.
  2. 2At the wheels, check that the sensor cable is intact and secure.
  3. 3Can you reach it? Clean the sensor and the sensor ring.
  4. 4Have the signals from all wheels compared during a test drive.
  5. 5Replace the faulty sensor.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

With a missing signal, the Saab 9-4X limits the automatic gearbox to fifth gear and reverse.

According to the ANWB (the Dutch motoring club), repairing or replacing an ABS sensor usually costs 200 to 300 euros.

  1. Code appears

    The computer stores the fault.

  2. Automatic gearbox

    The gearbox can go into limp mode.

  3. ABS warning light also on

    On a car from after 31 December 2017, that means you fail the APK. On an older car you get repair advice.

Background

FrontMaster cylinderBrake lineABS unit withpump and valvesABS sensorWheelSensors measure wheel speed
How ABS works
How it works ›

Where the speed signal comes from

The engine computer needs the road speed. On an automatic gearbox, it comes from a sensor on the output shaft of the gearbox. In the Saab 9-4X this is a Hall sensor that gets an 8.3 to 9.3 V supply from the gearbox computer.

On many cars, the ABS wheel sensors supply the speed. HELLA describes sensors that measure from as low as 0.1 km/h.

When the computer sets the code

P0500 means that the speed signal is missing or incorrect. Saab reports a missing output shaft signal as P0722: the shaft speed stays at 70 rpm or lower for 4 seconds while the engine is pulling.

HELLA names as causes a broken cable, a short circuit, dirt, play in the wheel bearing and a damaged sensor wheel.

In numbers

Output shaft sensor supply (Saab 9-4X automatic)
8.3 to 9.3 V1
No-signal limit (Saab 9-4X automatic)
70 rpm or less, 4 s1
Automatic gearbox response
Fifth gear and reverse only1
Measuring range of a modern wheel sensor
From 0.1 km/h2
Replacing an ABS sensor (ANWB)
€200 to €3003

Questions

Will my car fail the APK (the Dutch MOT) on P0500?

Not on P0500 itself. If the ABS warning light is also on, it will fail on a car first registered after 31 December 2017. On an older car you get repair advice.

Why does my automatic gearbox shift oddly?

The gearbox picks its moment based on the speed. Without a proper signal it sometimes selects the wrong gear.

Is driving without a speedometer allowed?

You must be able to check your speed. So have it fixed soon.

See also

Was this helpful?

· 4 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 automatic 6T70: DTC P0722 or P0723 (factory manual)
  2. HELLA Tech World, Check and change ABS and wheel speed sensors
  3. ANWB, ABS: anti-lock braking system (in Dutch)
  4. RDW, APK handbook Regulations, article 5.2.31 and 5.2.47 and repair advice points (version from 1 January 2024) (in Dutch)