- How bad
- Within a month
- Do it yourself
- Possible, if you are handy
- Garage
- €1,800 to €2,500
What you notice
- The engine warning light is on
- The speedometer drops out or jumps
- The automatic gearbox shifts irregularly
- Cruise control does not work
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty speed sensor on the gearbox | Common |
| Loose or corroded connector | Common |
| Dirty or faulty ABS sensor (if it supplies the speed) | Sometimes |
| Damaged wiring | Sometimes |
| Tyre size different from the factory size | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Read all codes, including in the ABS module. An ABS code points to a wheel sensor.
- 2Watch whether your speedometer drops out while driving.
- 3Check the connector on the speed sensor at the gearbox.
- 4Have the speed signal viewed live during a test drive.
- 5Replace the sensor that reads wrong.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
With a fault in this signal, the Saab 9-4X limits the automatic gearbox to fifth gear and reverse.
According to the ANWB (the Dutch motoring club), repairing or replacing an ABS sensor usually costs 200 to 300 euros.
Code appears
The computer stores the fault.
Automatic gearbox
The gearbox can go into limp mode.
At the APK
The APK (the Dutch MOT) inspector measures the exhaust gases, as with any stored P-code.
What it costs
It depends on the cause. Where do the prices come from? ›
Background
How it works ›
Where the speed signal comes from
The engine computer needs the road speed. With an automatic gearbox it comes from a sensor on the output shaft of the gearbox. In the Saab 9-4X this is a Hall sensor. It gets an 8.3 to 9.3 V supply from the gearbox computer.
On many cars, the ABS wheel sensors supply the speed.
When the computer sets the code
Saab reports an intermittent output shaft signal as P0723. This happens when the speed drops by more than 650 rpm without recovering within 1.5 seconds.
The manual mentions damaged teeth on the wheel the sensor reads and metal particles on the sensor tip. The sensor bolt must be tightened to the correct torque. For wheel sensors, HELLA also mentions play in the wheel bearing.
In numbers
Questions
Where is the speed sensor?
On older cars it is usually on the gearbox. Many newer cars take the speed from the ABS sensors at the wheels.
Can the ABS light also come on with P0501?
Yes, if an ABS sensor supplies the speed signal. There is then often also a code in the ABS module.
Will P0501 fail the APK?
Not on the code alone. Because of the P-code, the APK (the Dutch MOT) inspector does a standard exhaust gas test.
See also
Was this helpful?
· 4 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.