Skip to content

P0641: Sensor reference voltage A: circuit open

The 5 V supply from your engine computer to a group of sensors is dropping out. Often one faulty sensor or cable pulls the whole group down.

This weekDrive as little as possible. Have it checked this week. More sensors can drop out.

How bad
This week
Do it yourself
No, that is a garage job
Garage
€89

What you notice

  • The engine warning light is on
  • Limp mode
  • Many sensor codes at once
  • Sometimes the car does not start

What usually causes it

CauseLikelihood
Short circuit in a sensor on this supplyCommon
Broken or chafed wiringCommon
Corroded connectorSometimes
Faulty engine computerRare

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1See which other sensor codes are stored. They often belong to the same supply.
  2. 2Ignition on. Unplug the sensor connectors one by one. If the voltage comes back, you have found the culprit.
  3. 3Look for chafed cables near hot or moving parts.
  4. 4Have the garage follow the wiring diagram and measure.
  5. 5Replace the faulty sensor, or have the wiring loom repaired.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

On the Saab 9-4X V6 this is a type A code: the engine warning light comes on immediately. The Saab 9-5 diesel switches to reduced power.

Expect more codes at once, because every sensor on the circuit gives a wrong value.

  1. First drive with the fault

    The engine warning light comes on immediately.

  2. While driving

    Several sensors give a wrong value. The car can limit its power.

  3. At the APK

    With a P-code, the APK (the Dutch MOT) inspector measures the exhaust gases in the standard way.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Camshaft position sensorGarage €89Part €24
Throttle bodyGarage nonePart €133

Background

Vroom Doctor in the OBD port under the steering wheel, above the pedals
How it works ›

What the 5 V supply is

Many sensors get a stable 5 V supply from the engine computer. The computer has several circuits for this. In the Saab 9-4X V6 there are four, and each circuit feeds more than one sensor.

There, circuit 1 feeds the tank pressure sensor, the barometric pressure sensor, the rail pressure sensor, the air conditioning pressure sensor and all four camshaft position sensors.

When the computer sets the code

P0641 means the voltage on circuit 1 is wrong. The Saab 9-5 diesel sets the code at more than 5.5 V or less than 4.5 V, for longer than half a second.

A short circuit in one sensor or wire affects all sensors on the same circuit. According to the manual, you unplug the sensors one by one and see when the voltage comes back. If the fault stays with everything unplugged, it is in the wiring loom.

In numbers

Number of 5 V circuits (Saab 9-4X V6)
41
Limit (Saab 9-5 diesel)
Above 5.5 V or below 4.5 V, longer than 0.5 s2
Engine warning light on (Saab 9-4X V6)
Immediately, at the first failed test3
Computer response (Saab 9-5 diesel)
Reduced power2
Engine warning light goes off
After 3 drives in a row without the fault4

Questions

Which sensors are on reference voltage A?

That differs per engine. Often pressure sensors, the throttle sensor or the camshaft position sensor.

Is my engine computer broken?

Usually not. Often a sensor or cable is pulling the voltage down.

Why do I suddenly get so many codes?

If the supply drops out, several sensors lose their power at once. Each of those sensors then reports a fault.

See also

Was this helpful?

· 5 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0641, P0651, P0697 or P06A3 (factory manual)
  2. Saab WIS, 9-5 2011 diesel: DTC P0641 (factory manual)
  3. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  4. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  5. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.