- How bad
- Within a month
- Do it yourself
- No, that is a garage job
- Garage
- €300 to €650
What you notice
- The car does not start in P or N
- The reversing light does not work
- Wrong position shown in the display
- Odd gear changes
What usually causes it
| Cause | Likelihood |
|---|---|
| Faulty range sensor (multifunction switch) | Common |
| Sensor incorrectly adjusted | Sometimes |
| Connector or wiring damaged | Sometimes |
| Moisture in the connector | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1If it does not start in P, try it in N.
- 2Move the selector. Does the display show the correct position?
- 3Have the connector and wiring on the gearbox checked.
- 4Have the sensor adjusted or replaced.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
With this fault, the Saab sets the fluid pressure to maximum. It also limits the gearbox to fifth gear and reverse. HELLA lists the gearbox limp mode and an engine warning light that comes on as consequences.
According to the ANWB (the Dutch motoring club), a gearbox overhaul costs about 2,500 euros, including fitting.
Code appears
The gearbox goes into limp mode.
Starting
If the computer sees no P or N, the engine may refuse to start.
At the APK
With a P code, the APK (the Dutch MOT) inspector measures the exhaust gases the normal way.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Starter motor | Garage €375 | Part €141 |
Background
How it works ›
What the range sensor does
The sensor tells the gearbox computer which position the gear selector is in. In the Saab 9-4X it is a sliding switch on the shift shaft, inside the gearbox. It gives four signals. The combination stands for P, R, N or D.
A separate switch for P and N goes to the engine computer. The engine computer uses it to release the starter motor.
When the computer sets the code
P0705 means the computer cannot determine the position. Saab reports this as P182E: the switch gives no valid combination for P, R, N or D for 7 seconds.
HELLA lists broken wires, short circuits, damage and metal particles on the sensor as causes.
In numbers
- Range switch signals (Saab 9-4X automatic)
- 4, together standing for P, R, N or D1
- Threshold (Saab 9-4X automatic)
- 7 s without a valid position1
- Gearbox response
- Maximum fluid pressure, fifth gear and reverse only1
- P/N signal
- Releases the starter motor2
- Gearbox overhaul (ANWB)
- About €2,500, including fitting4
Questions
Why won’t my automatic start?
The car only starts when the computer sees that it is in P or N. With a faulty range sensor, it cannot see that.
Is P0705 dangerous?
The gearbox may be in a different position than you think. So always check that it is really in P before you get out.
What does a new range sensor cost?
That depends on how easy it is to reach. Garages charge €75 to €103 per hour.
See also
Was this helpful?
· 5 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
- Saab WIS, 9-4X 2011 automatic 6T70: DTC P182E or P1915 (factory manual)
- Saab WIS, 9-4X 2011 automatic 6T70: DTC P0850 to P0852 (factory manual)
- HELLA Tech World, Transmission range sensor: function and troubleshooting
- ANWB, Gearbox (in Dutch)
- RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.