Skip to content

P0133: Lambda sensor slow response (bank 1, sensor 1)

Your first lambda sensor (oxygen sensor) on bank 1 responds too slowly to the mixture. Usually it is worn. Replacing it at the garage costs €112 to €120.

No rushYou can keep driving. Fix it within a few months, or before your next APK (the Dutch MOT).

How bad
No rush
Do it yourself
Possible, if you are handy
Usually
Worn lambda sensor

What you notice

  • The engine warning light is on
  • Higher fuel consumption
  • Slightly less power

What usually causes it

CauseLikelihood
Worn lambda sensor · €116Common
Sensor fouled by oil or coolant · €116Sometimes
Exhaust leak before the sensorSometimes
Air leak in the intakeSometimes

A code points to the area. Sometimes the garage only finds the real cause after that.

How to fix it

Start with what costs least.

  1. 1If there are also codes for a lean mixture or misfire, fix those first.
  2. 2Check the exhaust before the sensor for leaks.
  3. 3Look at the sensor signal in the app, at 2,500 rpm. It should switch quickly.
  4. 4Replace the lambda sensor.
  5. 5If the new sensor fouls quickly, have the engine checked for oil or coolant consumption.

What to ask the garage

  • Which other codes are stored, and can I have the printout?
  • Which measurement shows that this is the cause?
  • What does an original part cost, and what does a pattern part cost?
  • What will it cost if you find more? Call me before you go ahead.

If you wait

A slow sensor corrects the mixture too late. The manual names a mixture that is too lean or too rich as a cause of damage to the catalytic converter.

According to the ANWB (the Dutch motoring club), a new catalytic converter costs 500 to 1,000 euros.

  1. First drive with the fault

    The computer stores the fault.

  2. Second drive in a row

    The light comes on.

  3. Months of driving on

    The mixture is corrected too late. That puts strain on the catalytic converter.

  4. At the APK

    The APK inspector measures the exhaust gases. If they are too high, you fail the APK.

What it costs

It depends on the cause. Where do the prices come from? ›

PartAt the garagePart only
Lambda sensorGarage €116Part €79
Catalytic converterGarage €339Part €240

Background

Engine managementLambda sensorbefore converterLambda sensorafter converterCatalytic converterEngineControls the mixtureChecks the converter
How the lambda sensors measure
How it works ›

What the front lambda sensor does

The lambda sensor compares the oxygen content in the exhaust gases with that of the outside air. From that it produces a voltage. It runs from 0 to 1,275 mV. Towards 1,000 mV the mixture is rich, towards 0 mV lean.

Sensor 1 sits before the catalytic converter. The engine computer controls the mixture on its signal. Straight after the start, it waits until the sensor is warm and the signal starts to switch.

When the computer sets the code

The Saab 9-4X V6 measures how long the sensor takes to switch from rich to lean and back. If that average response time is too long, the computer sets P0133 within 60 seconds.

The test runs once per drive: engine warmer than 71 °C, 1,000 to 3,000 rpm and an airflow of 15 to 55 g/s. The tank must be more than 10 percent full.

In numbers

Sensor signal range
0 to 1,275 mV1
Test runs at (Saab 9-4X V6)
Above 71 °C, 1,000 to 3,000 rpm, 15 to 55 g/s1
Tests per drive
11
New catalytic converter (ANWB)
€500 to €1,0003
Engine warning light on
On the second drive in a row with the same fault4
Engine warning light goes off
After 3 drives in a row without the fault5

Questions

How long does a lambda sensor last?

Often 100,000 to 160,000 km. Oil consumption or coolant in the combustion shortens that.

Can P0133 damage the catalytic converter?

In the long run, yes. The mixture is controlled less well. So do not wait too long.

Will P0133 make you fail the APK (the Dutch MOT)?

Not on the code alone. With a P code, the APK inspector measures the exhaust gases in the normal way. You only fail the APK if they are too high. The rules per fuel type are in the APK guide. This fault can raise emissions.

See also

Was this helpful?

· 6 sources · In het Nederlands

Sources

All sources checked on 19 November 2026.

  1. Saab WIS, 9-4X 2011 V6: DTC P0133, P013A to P014B, P0153, P1133 or P1153 (factory manual)
  2. Saab WIS, 9-4X 2011 V6: DTC P0420 or P0430 (factory manual)
  3. ANWB, What is a catalytic converter and when does it need replacing? (in Dutch)
  4. Saab WIS, 9-4X 2011: Powertrain DTC Type Definitions (factory manual)
  5. UNECE Regulation No. 83, Annex 11 (OBD), paragraphs 3.3 to 3.8
  6. RDW, APK manual Regulations, articles 42 and 45a to 45g (version from 1 January 2024) (in Dutch)
How we set prices ›

The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.