- How bad
- Within a month
- Do it yourself
- No, that is a garage job
- Garage
- €1,800 to €2,500
What you notice
- The engine warning light or gearbox warning light is on
- Harsh or late gear changes
- The gearbox stays stuck in one gear
- Slipping between gears
What usually causes it
| Cause | Likelihood |
|---|---|
| Too little or old fluid in the gearbox | Common |
| Faulty pressure sensor or pressure switch | Common |
| Loose or dirty connector on the gearbox | Sometimes |
| Sticking shift valve in the valve body · €2,150 | Sometimes |
| Wear inside the gearbox · €2,150 | Rare |
A code points to the area. Sometimes the garage only finds the real cause after that.
How to fix it
Start with what costs least.
- 1Read all codes, including those in the gearbox module.
- 2Have the gearbox fluid level checked the way the manufacturer specifies.
- 3Check that the connector on the gearbox is secure and dry.
- 4If the fluid is dark or smells burnt, have it changed.
- 5Have the pressure sensor tested and replaced. On many gearboxes it sits in the valve body.
What to ask the garage
- Which other codes are stored, and can I have the printout?
- Which measurement shows that this is the cause?
- What will it cost if you find more? Call me before you go ahead.
If you wait
On a Saab this is a type C code. The engine warning light stays off. The gearbox stops adapting the shift points for this clutch.
The manual names dirt in the fluid as the cause of a switch that sticks now and then. At first you notice nothing. Complaints only appear when the fault lasts a long time.
Code appears
The engine warning light stays off and you usually notice nothing.
Fault lasts a long time
Gear changes may get worse.
At the APK
With this P code too, the APK (the Dutch MOT) inspector measures the exhaust gases.
What it costs
It depends on the cause. Where do the prices come from? ›
| Part | At the garage | Part only |
|---|---|---|
| Gearbox | Garage €2,150 | Part none |
Background
How it works ›
What the pressure switch does
In an automatic gearbox, fluid pressure operates the clutches. A pressure switch shows the gearbox computer whether a control valve is in the right position.
In the Saab 9-4X, switch 1 sits in the valve body with the solenoid valves. It cannot be replaced separately. Without pressure it is closed, with pressure it is open. It belongs to the clutch for third and fifth gear and reverse.
When the computer sets the code
Saab counts each time the switch stays in the wrong position after a clutch change. After 25 times too low, P0842 follows. After 35 times too high, P0843 follows.
The test runs at a fluid temperature of -7 to 120 °C.
In numbers
- Location (Saab 9-4X automatic)
- In the valve body, cannot be replaced separately1
- Threshold P0842
- 25 times signal too low after a change1
- Threshold P0843
- 35 times signal too high after a change1
- Fluid temperature during test
- -7 to 120 °C1
- Engine warning light (Saab 9-4X automatic)
- Stays off, type C1
- Gearbox overhaul (ANWB)
- About €2,500, including fitting2
Questions
Can fresh fluid fix P0841?
Sometimes. With too little or dirty fluid, the pressure is not right.
What does a new pressure sensor for an automatic gearbox cost?
If the sensor is mounted separately on the gearbox, replacing it is cheaper than when it sits in the valve body.
Is my automatic gearbox broken with P0841?
Usually not. Start with the fluid, the connector and the sensor. Damage inside the gearbox is the least likely cause.
See also
Was this helpful?
· 4 sources · In het Nederlands
Sources
All sources checked on 19 November 2026.
How we set prices ›
The amounts come from prices that Dutch garages and webshops publish on their own sites, including VAT, or from the source shown next to them. Last collected on 19 November 2026. Your own price depends on your engine and year, so always ask for a quote. The ANWB (the Dutch motoring club) gives an average, which is not a real price, so we leave it out. If your garage asks something very different, email it to hallo@vroomdoctor.com.